Abstract:The thermal stability of the dual phase AlCrFeCoNiCu 0.5 high entropy alloy thin films at up to 600 °C under vacuum was studied through detailed characterization. The evolution of microstructure and chemical composition was revealed by X-ray diffraction, transmission Kikuchi diffraction and transmission electron microscopy . Also, the mechanical properties were measured by nanoindentation . Although the crystalline phase of all the HEA thin films was BCC-dominated, the FCC phase fraction increased from 16.6% (as-deposited) to 28.1% (600 °C-annealed). The as-deposited films exhibited a columnar morphology with an average grain size of 106.1 nm for length and 31.3 nm for width and remained the columnar shape until 600 °C. The columnar grains showed an increasing tendency of size at 200 °C (221.3 nm and 45.6 nm for length and width) and 400 °C (283.9 nm and 56.2 nm). At 600 °C, the columnar grain size decreased to 211.8 nm in length and 59.3 nm in width. Concurrently, the occurrence of new equiaxed grains was observed with an average diameter of 42.4 nm. The reduction of columnar grain size and the formation of equiaxed grains at 600 °C were explained based on the energy dispersive spectroscopy. Although no preferential evaporation was found, the elemental distribution revealed the formation of two secondary phases, i.e., Cu-rich FCC phase and Cr-rich BCC phase. The nanoindentation results indicated that the mechanical properties increased as the increase of annealing temperature. The hardness and elastic modulus of 600 °C-annealed sample were 8.5 ± 0.3 GPa and 205.4 ± 3.5 GPa, respectively, which were 10.4% and 41.5% higher than those of the as-deposited thin film. These findings are critical for a fundamental understanding of the microstructure and properties change of the dual-phase HEA thin films in high working temperatures.

Unraveling Microstructure Evolution During Isothermal Annealing Treatment in Dual-Phase FeNiCr0.8Al0.8 High Entropy Alloy and Its Effect on Corrosion Behavior

Unraveling Microstructure Evolution During Isothermal Annealing Treatment in Dual-Phase FeNiCr 0.8 Al 0.8 High Entropy Alloy and Its Effect on Corrosion Behavior

Corrosion behavior and mechanism of dual phase Fe1.125Ni1.06CrAl high entropy alloy

Microstructural Evolution and Elevated-Temperature Strengthening Mechanism of Co-free FeCrMnNiV0.2Alx High-Entropy Alloys During Annealing

Influence of Cr on Microstructure and Electrochemical Properties of FeNiMnCuCrx High-entropy Alloy

Microstructure and Corrosion Behavior of AlCoCrFeNiSi0.1 High-Entropy Alloy

Effect of annealing temperature on the microstructure evolution and corrosion behavior of Carbon-interstitial FeMnCoCrNi high-entropy alloys

Microstructure, mechanical properties and corrosion resistance of direct energy deposited AlCu 0.25 CoCrFeNi 2.1 high entropy alloy: Tailored by annealing heat treatment

Optimizing corrosion resistance of equiatomic AlCoCrFeNi high entropy alloys via heat treatment

Insight into the microstructure and micromechanical behavior and mechanism of the constitutional phase of FeNiCrAl 0.63 multi-principal element alloy

Insight into the Microstructure and Micromechanical Behavior and Mechanism of the Constitutional Phase of FeNiCrAl0.63 Multi-Principal Element Alloy

Effect of microstructural evolution on corrosion behavior of Al0.7Cr2FeCoNi high-entropy alloy

Microstructural evolution, mechanical and corrosion behavior of an Al7.5Co20.5Fe24Ni24Cr24 high‐entropy alloy

Phase, Microstructure and Corrosion Behaviour of Al0.3FeCoNiCrx High-Entropy Alloys via Cr Addition

Effect of annealing temperature on microstructure and corrosion behavior of CoCrFeMnNi high-entropy alloy in alkaline soil simulation solution

Effect of annealing temperature on the structure and properties of FeCoCrNiMo high-entropy alloy

The microstructural evolution of dual phase high entropy alloy thin films by annealing

Insight into microstructure evolution on anti-corrosion property of AlxCoCrFeNiC0.01 high-entropy alloys using scanning vibration electrode technique

Annealing-induced multi-heterogeneous microstructure strengthening in FeCoCrNiMo 0.2 high-entropy alloys

Effect of Annealing on Microstructure and Corrosion Behavior of Interstitial Free Steel

Corrosion behaviors of amorphous and nanocrystalline Fe-based alloys in NaCl solution