Abstract:Supercapacitors are gaining increasing attention for complementing or replacing batteries and they are highly desirable in applications where high power and long cycle life of energy storage devices are needed. Activated carbons (AC) are the most promising electrodes in the supercapacitor industry presenting the best performances/cost compromise. Recently, graphene, with a two dimensional carbon nanostructure, has emerged as a new class of promising electrode material in supercapacitors, due to its outstanding properties such as high electric conductivity, high surface area, good mechanical properties and chemical inertia. Among the various approaches to producing graphene materials, here we focus on reduced exfoliated graphene oxide (r-GO) derived from chemically synthesised graphene oxide (GO). However, the graphene materials prepared by either chemical or thermal reduction of the graphene oxide always exhibits a relatively low electrochemical performance due to the agglomeration of graphene sheets and does not reflect the intrinsic capacitance of an individual graphene nano-sheet. To exploit the potential electrochemical applications for graphene, a particularly attractive option is to design and develop composites of graphene with other materials. In this study, we present an approach to synthesize a composite of reduced graphene oxide (r-GO) with activated carbon and its use as an electrode material in supercapacitors. To the best of our knowledge, a few studies on the preparation of GO/AC composites have been reported so far. Graphene oxide was synthesised using vein graphite by a modified Hummers method and then mixed with activated carbon to prepare a homogeneous composite. The composite was thermally reduced to convert GO in to r-GO. The morphology and chemical structure of the materials were characterized by means of Electron microscopy, Raman spectroscopy, X-ray diffraction and Fourier Transform Infrared Spectroscopy. Thermal properties were investigated using Thermo Gravimetric Analysis. The electrochemical properties of as obtained composites with different mass ratios were investigated, together with their individual components (GO, r-GO and AC) for comparison. For electrochemical characterisation, two-electrode symmetrical supercapacitor cells were constructed and characterized by cyclic voltammetry and electrochemical impedance spectroscopy. Tetraethylammonium tetrafluoroborate (TEABF4) in Propylene Carbonate (PC) was used as the electrolyte. The CV curves were measured from 0 to 1 V with various scan rates ranging from 10 to 1000 mV s −1 and the CV data were used to calculate the specific capacitances of the electrodes. The results showed that the as-prepared composites exhibited an improved electrochemical performance as compared to pure r-GO or AC. This improvement can be attributed to the synergistic effect of AC and r-GO. The maximum specific capacitance observed for the r-GO/ AC composite was 115.6 F/g at a scan rate of 10 mV s -1 . The near-rectangular CV curves at ultrafast sweep rate of 1000 mV s -1 indicated very efficient charge transfer within the composite electrodes. The incorporation of rGO into AC, not only provides the vacancies to accommodate ions, but also forms a promising network structure to conductively bridge the spaces between the AC particles, which can facilitate rapid transport of the electrolyte ions within the electrode materials, leading to a high-rate performance of the supercapacitor. Within the composite, r-GO plays the role of both the binder and the conductive additive increasing the specific capacitance and the power density of the devices.

Reduced Graphene Oxide Film Modified by Tannic Acid for High Areal Performance Supercapacitors

Graphene Aerogel Derived by Purification-Free Graphite Oxide for High Performance Supercapacitor Electrodes

Supercapacitors Based on Low-Temperature Partially Exfoliated and Reduced Graphite Oxide

A Simple Approach towards Highly Dense Graphene Films for High Volumetric Performance Supercapacitors

Functionalized Three-Dimensional Graphene Networks for High Performance Supercapacitors

Self-assembled Reduced Graphene Oxide Films with Different Thicknesses As High Performance Supercapacitor Electrodes

In-situ reduction of graphene oxide for electrochemical supercapacitor application

Graphene Oxide and Activated Carbon Composites for High-Power Supercapacitors

Synergistic Effect of Anion and Cation in Oxalic Acid for Graphene Surface Engineering and Its Enhanced Pseudocapacitance Performance

A Two-Step Thermal Treatment Method to Produce Reduced Graphene Oxide with Selectively Increasing Electrochemically Active Carbonyl Group Content for High-Performance Supercapacitor Electrode

Free-standing Ultrathin CoMn2O4 Nanosheets Anchored on Reduced Graphene Oxide for High-Performance Supercapacitors.

Fabricating Reduced Graphene Oxide Films with High Volumetric Capacitive Performances Via Thermal and Acid Treatment

ZnCo2O4-reduced Graphene Oxide Composite with Balanced Capacitive Performance in Asymmetric Supercapacitors

Covalent modified reduced graphene oxide: Facile fabrication and high rate supercapacitor performances

Facile one-step hydrothermal synthesis of reduced graphene oxide/Co 3 O 4 composites for supercapacitors

Facile one-step hydrothermal synthesis of reduced graphene oxide/Co3O4 composites for supercapacitors

Customizing oxygen–containing functional groups for reduced graphene oxide film supercapacitor with high volumetric performance

Reduced Graphene Oxide Hydrogel for High Energy Density Symmetric Supercapacitor with High Operation Potential in Aqueous Electrolyte

Reduced Graphene Oxide/poly(aniline-Co-toluidine Blue): Binder-free Electrodes for High-Performance Quasi-Solid-state Symmetric Supercapacitors

Pseudocapacitive Anthraquinone Modified with Reduced Graphene Oxide for Flexible Symmetric All-Solid-state Supercapacitors

Enhanced supercapacitor performance through synergistic electrode design: Reduced graphene oxide-polythiophene (rGO-PTs) nanocomposite