Abstract:3D-printed carbon fiber composites hold significant potential in aerospace applications because of their lightweight, high strength and complex structure fabrication capabilities. However, additive manufacturing characteristics such as high porosity, anisotropy and continuous fiber content significantly affect the mechanical properties of printed parts. The aim of this study is to investigate the influence of hybrid printing of short and continuous carbon fibers on the mechanical properties and failure mechanisms of composites and to develop a model to predict elastic properties considering porosity. First, mechanical testing and characterization of short and continuous fiber reinforced polyamide (nylon) print filaments are performed. The results indicate that the elastic modulus and ultimate strength of continuous carbon fiber filaments reach 60 GPa and 1500 MPa, respectively, while the strength and elastic modulus of short carbon fiber filaments reach 60 MPa and 1 GPa, respectively. Then tensile specimens with different continuous fiber orientations and different continuous fiber placement sequences are printed and tested using a multi-material 3D printing technique. The specimens are characterized before and after testing using scanning electron microscopy and microscopy to assess the porosity and failure mechanisms of specimens with different configurations. The results show that the mechanical properties of the printed parts are much lower than those of the print filaments, which proves the serious negative impact of the material extrusion process on the mechanical properties of the printed structural parts. Finally, an analytical method for predicting the elastic behavior of printed composites is developed by introducing the porosity factor in the volume-averaged stiffness model. For continuous and short fiber filled composites with different fiber contents and printing orientations, the predicted results are in agreement with the experiments, and the prediction error is greatly reduced from 30% to less than 5%.

Mechanical Properties of 3D Continuous CFRP Composite Graded Auxetic Structures

Compressive properties and failure mechanisms of 3D-printed continuous carbon fiber-reinforced auxetic structures

Quasi-static and dynamic behavior analysis of 3D CFRP woven laminated composite auxetic structures for load-bearing and energy absorption applications

Experimental and Theoretical Studies on 3D Printed Short and Continuous Carbon Fiber Hybrid Reinforced Composites

Study on the mechanical properties of CFRP composite auxetic structures consist of corrugated sheets and tubes

Three-dimensional Auxetic Structure Design Methods Based on Bulking-Induced Deformation and the Application in Soft Crawling Robot

Experimental and Numerical Analysis of a Novel Assembled Auxetic Structure with Two-Stage Programmable Mechanical Properties

Graded metastructure design for linearly auxetic deformation under tension: From 2D honeycombs to 3D truncated cones

Low‐velocity impact response of 3D carbon fiber reinforced polymer auxetic lattice structures

Mechanical and Self-Monitoring Behaviors of 3D Printing Smart Continuous Carbon Fiber-Thermoplastic Lattice Truss Sandwich Structure

Rate-dependent mechanical and self-monitoring behaviors of 3D printed continuous carbon fiber composites

In-Plane Compression Properties of Continuous Carbon-Fiber-Reinforced Composite Hybrid Lattice Structures by Additive Manufacturing

Mechanical Performance and Failure Analysis of a 3D-Printed "Continuous Layer–Lattice Layer–Continuous Layer" Sandwich Structure

Mechanical Behaviors of Composite Auxetic Structures under Quasi-Static Compression and Dynamic Impact

Compression and resilient behavior of graded triply periodic minimal surface structures with soft materials fabricated by fused filament fabrication

Compression behavior and energy absorption of 3D printed continuous fiber reinforced composite honeycomb structures with shape memory effects

Energy absorption response of functionally graded 3D printed continuous fiber reinforced composite cellular structures: Experimental and numerical approaches

Design and Manufacturing of a Composite Lattice Structure Reinforced by Continuous Carbon Fibers

Bending performance and failure behavior of 3D printed continuous fiber reinforced composite corrugated sandwich structures with shape memory capability

Fabrication and crushing response of graded re-entrant circular auxetic honeycomb

Bioinspired 3D‐Printed Auxetic Structures with Enhanced Fatigue Behavior