Abstract:In this study, a test technique that enables continuous control of the sample stress state from freezing to testing is proposed to investigate the influence of freezing pressure on the mechanical properties of ice under uniaxial compression. In this method, the water is frozen into the standard cylindrical ice specimen under high hydraulic pressure in a triaxial pressure chamber, and then, the temperature field and stress field of the ice specimens are adjusted to the initial state of the test; finally, an in situ mechanical test is conducted in the triaxial chamber. The uniaxial compression test of ice specimens with temperature of −20°C and freezing pressure of 0.5–30 MPa is performed in the strain rate range of 5 × 10−5−1.5 × 10−6 s−1. The results show that, as the freezing pressure increases, the ductile-to-brittle transition zone of the ice specimen during failure moves to the low strain rate range, and the failure mode of the specimen changes from shear failure to splitting failure. Further, the brittleness index of the ice specimen first increases, then decreases, and then again increases with the increase in freezing pressure. The brittleness index reaches the maximum (minimum) when the freezing pressure is 30 MPa (20 MPa). The peak stress of the ice specimen also increases first, then decreases, and then increases with the increase in freezing pressure. The maximum value is also at the freezing pressure of 30 MPa, but the minimum value is obtained at the freezing pressure of 0.5 MPa. The failure strain of the ice specimen first decreases and then increases with the increase in freezing pressure, and the maximum (minimum) value is achieved at the freezing pressure of 0.5 MPa (10 MPa). When the ice specimen exhibits brittle failure, the relationships between the residual stress and the freezing pressure and between the peak stress and freezing pressure are the same, but when the ice specimen exhibits ductile failure, there is no obvious relationship between the residual stress and the freezing pressure.

Comparative Experimental Study of the Effect of Loading Rate on the Typical Mechanical Properties of Bubble and Clear Ice Cubes

Effects of Environmental Temperature and Trapped Air Bubbles on the Mechanical Properties of Ice Cubes

Experimental Technique for Ice under Dynamic Compressive Loading

Experimental study on the distribution and growth characteristics of trapped air bubbles in ice slices at different freezing temperatures

Growth and Distribution Characteristics of Trapped Air Bubbles in Ice Slices

Numerical Analysis of Two Icing Modes Affecting Ice Storage Time

Mechanical Analysis of the Critical Conditions for Trapping and Detachment of Microscale Air Bubbles on the Pure Water Freezing Front

Experimental Study on the Melting Characteristics Modulation of Cubic Ice Cubes with Different Trace Air Contents under Natural Convection Condition

Microstructure of Ice with Physical Crosslinking Structure and Its Mechanical Properties under Impact Load

An Exploratory Study on the Potentials of Removing Ice from Frozen Structures by Bubble Pulsation Energy

An Experimental Study on the Effect of CO2 Laser Powers on Melting Characteristics of Ice with Trapped Air Bubbles under Vertical Irradiation

Experimental Study on Heat Transfer Characteristics of Ice Melting Processes under Point-Source Bubble Flows

An Experimental Study on the Dynamics and Damage Capabilities of a Bubble Collapsing in the Neighborhood of a Floating Ice Cake

An Experimental Study on Ice Melting Processes under Point-Source Bubble Flows at Different Flow Rates

Modeling and Mesoscale Simulation of Ice-Strengthened Mechanical Properties of Concrete at Low Temperatures

Experimental Study on the Influence of Freezing Pressure on the Uniaxial Mechanical Properties of Ice

Dynamic mechanical behavior of ice with different cotton contents

Understanding the filling effect of ice on the mechanical properties of calcium silicate hydrate gel

Experimental Study on Adhesive Characteristics of Aircraft Dynamic Icing

Experimental Study on the Influences of Some Factors on Supercooling Degree in Icing Process

Changes of Water/Ice Morphological, Thermodynamic, and Mechanical Parameters During the Freezing Process