Abstract:The feedback spring rod of the armature assembly was eliminated in the double-redundancy electro-hydraulic servo valve (DREHSV), which employed a redundant design in contrast to the typical double-nozzle flapper electro-hydraulic servo valve (DNFEHSV). The pilot stage was mainly composed of four torque motors, and the double-system spool was adopted in the power stage. Consequently, the difficulty of spool displacement control was increased. By artificially changing the structural parameters of the simulation model in accordance with the theoretical analysis through AMESim, this paper aimed to study the dynamics and static characteristics of the DREHSV. The advantage of redundant design was further demonstrated by disconnecting working coils and setting the different worn parts of the spool. On the test bench, the necessary experiments were performed. Through simulation, it was discovered that when the clogged degree of the nozzle is increased, the zero bias value increases, the pressure and flow gain remain unchanged, and the internal leakage decreases. The pressure gain changes very little, the flow gain close to the zero position grows, the zero leakage increases significantly, and the pilot stage leakage changes very little as a result of the wear of the spool throttling edge. The basic consistency between the simulation curves and the experimental findings serve to validate the accuracy of the AMESim model. The findings can serve as a theoretical guide for the design, debugging, and maintenance of the DREHSV. The simulation model is also capable of producing a large amount of sample data for DREHSV fault diagnosis using a neural network.

Model-Based Real-Time Fault Monitoring Strategy for Hydraulic Servo Actuators

EXTENDED DISTURBANCE OBSERVER-BASED SLIDING MODE FAULT-TOLERANT CONTROL FOR THE DUAL-VALVE HYDRAULIC SERVO SYSTEM WITH REDUCED-ORDER MODEL

Effective Model Based Fault Detection Scheme for Rudder Servo System

Modeling and Analysis of Hydraulic Controlled Rotary Valve Excitation System

Active fault-tolerant control for the dual-valve hydraulic system with unknown dead-zone

Pressure Sensor Fault Diagnosis by Using Adaptive Robust Observers

Modeling and Fault Simulation of a New Double-Redundancy Electro-Hydraulic Servo Valve Based on AMESim

A Fault Detection and Isolation Method for Independent Metering Control System Based on Adaptive Robust Observer

A Fault Detection Method for a Practical Electro-Hydraulic Variable-Displacement Pump with Unknown Swashplate Moment.

Online Fault Diagnosis for Hydraulic Servo Systems Based on Strong Tracking Filter

Model Based Fault Detection of an Electro-Hydraulic Cylinder

High-Precision Control Solution for Asymmetrical Electro-Hydrostatic Actuators Based on the Three-Port Pump and Disturbance Observers

Redundant design and performance analysis of hydraulic power source for actuator

Time-delayed excavator robust control based on speed monitor

Fault-tolerant control of a hydraulic servo actuator via adaptive dynamic programming

A Combined Model-based and Intelligent Method for Small Fault Detection and Isolation of Actuators

Multisource Electrohydraulic Servo Valve Fault Status Diagnostic Algorithm Based on a Message Propagation Mechanism

Actuator failure compensation-based command filtered control of electro-hydraulic system with position constraint

Online Fault Identification of Digital Hydraulic Valves Using a Combined Model-Based and Data-Driven Approach

Research on High-Reliable Dual-Redundancy Electro-Mechanical Actuator Controller

Fault-tolerant control for an electro-hydraulic servo system with sensor fault compensation and disturbance rejection