Abstract:Submerged floating tunnel (SFT) is a new type of cable-supported structure system for strait crossing. Once the local anchor-cable suddenly fails, it will inevitably cause evident vibration and internal force redistributions of the structure. In order to study the dynamic responses and mechanical behaviors of the SFT subjected to abrupt anchor-cable breakage, a model test is conducted by a set of sensors installed on SFT for cable force, tube displacement and strain measurements. The transient dynamic signals following cable failure are tested and analyzed. Dynamic amplification factor (DAF) and dynamic coefficient (DC) are respectively used to evaluate the impact effect from the cable failure. Meanwhile, finite element simulations are also performed within ABAQUS. The establishments of the finished state of SFT before cable breakage and the dynamic cable failure process are presented both in the model test and FE model. Comparisons between the FE predicted values and the experimental results show a good agreement. On this basis, some influence factors are discussed in different cases of the cable-loss positions and the cable forces of ruptured cable, etc. The results show that the finished state of SFT under dead load (tube redundant buoyancy) after cable-force optimizations is more reasonable than that directly applying dead load without any cable-force adjustments, with more uniform cable force distribution and smaller tube deformation. Although the SFT suffers strong oscillations after sudden cable-breakage incident, no progressive collapse occurs when the safety margin of the rest structure is sufficient. The dynamic effect on remaining cable members due to sudden cable failure can be evaluated by DC method. A DC value of 1.5 is recommended to ensure the safety of SFT anchor-cables. When cable failure happens at the mid span of the tunnel, the deformation of SFT tube is most critical.

Computational Homogenization Method for the Bending Analysis of Submarine Power Cables

Dynamic Analysis of Towed Cable with Variable Length During Turning Maneuvers

Mechanical Analysis of a Type of Hybrid Spatial Structure Composed of Cables, Bars and Beams

Development of an Effective Modeling Method for the Mechanical Analysis of Three-Core Submarine Power Cables under Tension

An Investigation on Grounding System of AC Single-core Submarine Cable Based on Multi-conductor Analysis Theory

Bending Study of Submarine Power Cables Based on a Repeated Unit Cell Model

Study on static behaviour of cable domes

Fatigue Failure Analysis and Simulation Calculation of Submarine Suspended Pipelines

Research on Structure Optimization of Cold Dielectric High-Temperature Superconducting Cables

Mechanical Responses of Submarine Power Cables Subject to Axisymmetric Loadings

Analytical Model for the Bending of Parallel Wire Cables Considering Interactions among Wires

Dynamic Analysis of Submarine Cable During the Process of Laying Back to the Seabed

Global Responses of Exposed and Suspended Submarine Cables Due to Anchor Dragging

Bending Study of Copper Conductors from Power Cables

Investigation on Dynamic Response of J-tube Submarine Cable Around Monopile Foundation

A Coarsened-Shell-Based Cosserat Model for the Simulation of Hybrid Cables

Mechanical Behaviors and Experimental Study of Submerged Floating Tunnel Subjected to Local Anchor-Cable Failure

Electrothermal Coupling Analysis of Submarine Cables

Analysis Of Subsea Umbilical Mechanical Behavior Under Simultaneous Bending, Tension And Torsion

Study on Performance Degradation of Multi-Layer Spiral Superconducting Cable Under Bending Load

Analysis on Buckling Performance of Submarine Pipelines During Deepwater Pipe-Laying Operation