Abstract:Monitoring rotor blade vibrations is imperative in aero-engine testing and service. Blade tip timing (BTT), a promising technique for such monitoring, assesses the operational status of rotor blades through non-intrusive measurement of blade tip displacement. Traditional BTT technology relies on the Once-Per-Revolution (OPR) probe, which poses installation challenges and introduces measurement uncertainties in practical applications. This paper introduces a novel OPR-free approach, employing Adaptive Variable Reference Blades (AVRB) for non-intrusive measurement of rotor blade vibrations. The method assumes a stochastic mistuning of blades within the same stage, resulting in non-simultaneous resonance of blades at a given speed. In each revolution, the vibration level of individual blades is determined by assessing the deviation between the average speed of a blade, as measured by two adjacent BTT probes, and the average speed across the entire circumference. Consequently, a non-vibrating blade is adaptively identified and selected as the reference blade. The relative vibration levels among blades vary dynamically during different revolutions, influenced by mistuning features, leading to variability in the reference blades. These adaptive variable reference blades can then replace the OPR probe, aiding in the computation of vibration displacement and further parameter identification of blades. To validate the effectiveness of the proposed method, a five-degree-of-freedom numerical model is utilized for simulation. Additionally, experiments involving both a five-bladed disk and an eight-bladed disk are conducted to validate the proposed approach. Numerical simulations and two sets of test results demonstrate a fundamental agreement between the blade vibration displacement calculated using the proposed method and the outcomes obtained through the traditional BTT method with OPR. The relative error in the identified blade vibration frequency derived from the blade vibration displacement, as determined by both methods, does not exceed 1 %. Additionally, the relative error in the amplitude of the blade vibration displacement is within the range of 10 %.

A Kalman Filter-Based Method for Displacement Calculation of Blade Tip Timing

An Improved Key-Phase-Free Blade Tip-Timing Technique for Nonstationary Test Conditions and Its Application on Large-Scale Centrifugal Compressor Blades

A Recursive Calculation Method of Vibration Displacements Using Blade Tip Timing in Angular Domain

A New Method for Non-Uniform Under-Sampled Blade Tip Timing Signal Reconstruction

Research on Vibration Characteristics of Last Stage Blade Based on Blade Tip-Timing Technology

An error correction blade tip-timing method to improve the measured accuracy of blade vibration displacement during unstable rotation speed

A Novel OPR-free Method for Blade Tip Timing Based on Adaptive Variable Reference Blades

An Actual Angle of Arrival Fitting Method for Correcting Errors Induced by Speed Fluctuation in Blade Tip Timing System

Measurement Methodology: Blade Tip Timing: A Non-Contact Blade Vibration Measurement Method

Improved Non-contact Vibration Measurement Via Acceleration-based Blade Tip Timing

Blade Tip Timing for Multi-Mode Identification Based on the Blade Vibration Velocity

Blade Tip Timing Signal Filtering Method Based on Sampling Aliasing Frequency Map

Experimental Study on the Optimization of the Sensor Arrangement for Blade Tip Timing Measurement

Adaptive Iterative Approach for Efficient Signal Processing of Blade Tip Timing

A Novel Blade Vibration Monitoring Experimental System Based on Blade Tip Sensing.

Dynamic Strain Reconstruction of Rotating Blades Based on Tip Timing and Response Transmissibility

A blade tip-timing method without once-per-revolution sensor for blade vibration measurement in gas turbine engines

A Novel Method to Improve the Precision of BTT under Rapid Speed Fluctuation Conditions

A Virtual Blade Tip Timing Measurement Method for Foreign Object Damage

An Integrated Measurement Method of Blade Tip Clearance and Blade Vibration Based on Blade Tip Timing Technology

Improvement of BTT Precision Considering Transient Rotating Speed Fluctuations