Abstract:Spray cooling features with high heat flux and good temperature control ability, which has been widely used in industrial environments such as electronic devices and nuclear power plants. In this study, the transient process of droplet-wall collision under film and transition boiling conditions has been investigated experimentally via the high-speed shadowgraph imaging and state-of-the-art image processing techniques. Based on intensive test conditions, the impact morphology, number, size, trajectory, ejecting angle and velocity of secondary droplets are presented and analyzed comprehensively. In experiments, distilled water was the test fluid, with initial droplets at 3 ± 0.03 mm. Droplet collision velocity was calculated based on the center distance in two pre-collision frames. The Weber number changes from 15.4 to 104.2, while the wall temperature varies from 307.6 °C to 511.8 °C. The observed collision phenomena can be divided into four types, including rebound, rebound with secondary atomization, breakup with secondary atomization, and breakup. An Improved Cascade Gaussian Fitting method (ICGF), which performs well in the dense and mutually occlusive areas, is adopted for particle identification. The statistical results show that the secondary droplet diameter mainly distributes in the range of 0.02 mm to 0.2 mm under different Weber numbers. Under similar wall temperature conditions, the number of secondary droplets and the average diameter of secondary droplets increase with Weber number. Moreover, the separation mass ratio increased from 0.18 % to 2.29 %. Specifically, it is found that the amount and size of secondary droplets decrease significantly when the boiling mode transfers from transition to film. Based on the time-resolved shadowgraph images, a four-frame optimal estimation particle tracking algorithm is used to obtain the two-dimensional trajectory of the secondary droplets. The measured velocity distributes in the range of 0.3 m/s-4.0 m/s, mainly concentrating in the range of 0.5 m/s-2.0 m/s. The number and size variation with time is also analyzed, which indicates most of the secondary droplets are generated due to the strong instability in the transition boiling states.

Characterizing Boiling Behaviors in Water/ethanol Binary Droplet Impact on a Heated Plate

A Study on the Dynamic Collision Behaviors of a Hydrous Ethanol Droplet on a Heated Surface

Impact and boiling characteristics of a droplet on heated surfaces: A 3D lattice Boltzmann study

Evaporation and boiling of water-alcohol droplets: Dynamic characteristics of wetting and heat transfer

Droplet boiling on heated surfaces with various wettabilities

Inner Phase Change Behavior of Small Liquid Droplet on Heated Solid Surface

Droplet Evaporation to Boiling in Van Der Waals Fluid

Droplet impact on superheated surfaces with different wettabilities

Dynamic characteristics of droplet impact on heated surfaces near Leidenfrost temperature

Experimental and Theoretical Investigation of Contact-Angle Variation for Water–ethanol Mixture Droplets on a Low-Surface-energy Solid

Multiphase SPH Modeling of Water Boiling on Hydrophilic and Hydrophobic Surfaces

Measurement of Interacting Ethanol Droplets Evaporation at Moderately Elevated Temperature and Pressure Using Phase Rainbow Refractometry

Dynamic Behavior of Droplet Impact on Laminar Superheated Particles

Machine-assisted quantification of droplet boiling upon multiple solid materials

Interfacial heat transfer and boiling transition of the droplets on superheated surface with Leidenfrost effects

Numerical investigation of droplet impact on heated surfaces with pillars

Boiling evaporation characteristics of sessile droplets and its transition evaporation mode

Droplet impact dynamics on Janus-textured heated substrates

Droplet Impact on Superheated Micro-Structured Surfaces

Evaporation And Nucleate Boiling Of An Individual Droplet On Surfaces

N ov 2 01 1 Drop impact on superheated surfaces