Abstract:Epoxy and epoxide composites have a wide range of outdoor applications wherein they are affected by ageing. In this study, epoxy casting plates and epoxy-based composite rods for use in overhead conductors were prepared. A concurrent investigation concerning the ageing of epoxy resins and their carbon fibre composites was carried out via artificially accelerated experiments under hygrothermal and salt mist conditions. The moisture penetration along the depth, water absorption, appearance, hardness, density of the epoxy resins, and variation patterns of the impact strength and tensile strength of the epoxy-based composites were investigated. The ageing mechanisms were explored using Fourier transform infrared spectroscopy (FTIR) and scanning electron microscopy (SEM). Both ageing modes had essentially similar influences on the properties of the resins and their composites; moreover, they did not significantly affect the chemical structure and microstructure of the epoxy resin, with the physical adsorption of water primarily observed during the ageing process. The moisture absorption behaviour of the epoxy obeyed Fick's law. Although the water penetration rate in the salt mist ageing mode was slightly higher than that in the hygrothermal ageing mode during the early ageing stage, it was essentially the same during the later stage. The final moisture absorption rate at saturation was approximately 1.1% under both modes. The flexural strengths and impact strengths of the composites in both ageing modes followed a similar trend. They decreased gradually with the ageing time and then stabilized at almost the same value. The flexural strength was reduced from 803 MPa to 760 MPa and the impact strength from 383 J/m2 to 310 J/m2, indicating a decrease of approximately 5.4% and 19%, respectively. The absorbed water during the ageing process caused micro-cracks at the interface between the fibres and resin, weakening the interfacial strength and reducing the mechanical properties of the composites.

Effect of Hot-Air Ageing on Properties of Ethylene–propylene–diene Monomer (EPDM) Rubber/samarium Borate/polyolefin and EPDM/antimony-doped Tin Oxide/polyolefin Composites

Influence of different antioxidants on cure kinetics and aging behaviours of ethylene propylene diene rubber/low density polyethylene blends

Enhanced Compatibility and Thermo-Oxidative Stability of Silicone Rubber/Ethylene–Propylene Terpolymer Composites Via in Situ Interface Coupling

Research on the Aging Effects of Adhesive and Composites on the Degradation Mechanism of Composite Adhesive Joints in Thermal-Humidity-Cycles for Automobiles

The effect of UV radiation ageing on the structure, mechanical and gas permeability performances of ethylene–propylene–diene rubber

The Effect of Thermal Aging on the Mechanical Properties of Ethylene Propylene Diene Monomer Charge Coating

Ageing behaviour and molecular/network structure evolution of EPDM/carbon black composites under compression and in thermal-oxidative environments

Effect of Decabromodiphenylethane on the Thermo-Oxidative Ageing Property of Epoxy Resin

Thermal Oxidative Aging and Service Life Prediction of Commercial Ethylene–Propylene–Diene Monomer Spacer Damping Composites for High–Voltage Transmission Lines

Degradation Characterization of Ethylene-Propylene-Diene Monomer (EPDM) Rubber in Artificial Weathering Environment

Constitutive Model for Thermal-Oxygen-Aged EPDM Rubber Based on the Arrhenius Law

Thermal–oxidative Degradation and Accelerated Aging Behavior of Polyamide 6/epoxy Resin‐modified Montmorillonite Nanocomposites

Aging Research of Ethylene-propylene-diene Monomer (EPDM) Rubber

Photo- and Thermo-Oxidative Degradation of Photocrosslinked Ethylene–propylene–diene Terpolymer

Chain dynamics evolution of ethylene‐propylene‐diene monomer in response to hot humid and salt fog environment

The Effect of Aging Process Conditions on the Thermal Properties of Poly(Dimethylsiloxane)-Based Silicone Rubber

Thermal Degradation and Thermo-oxidative Aging Behavior of Vinylidene Fluoride-Containing Fluoroether Rubber

Effect of crosslinked structure on the chemical degradation of EPDM rubber in an acidic environment

Effects of Hygrothermal and Salt Mist Ageing on the Properties of Epoxy Resins and Their Composites

Effect of antiaging agents on the outdoor natural weathering of bamboo powder/polypropylene foamed composites

Study of the influence of accelerated aging on the physical and mechanical properties of polymer composites containing rubber, polyethylene and poly(ethylene terephthalate) waste