Abstract:Abstract A water extraction device that takes water from air in dry area is proposed. This device is designed to meet domestic water demand in remote rural areas, where the climate is dry and fresh water is scarce. The device can be driven effectively by low-temperature waste heat and has the characteristics of large daily water production, low energy consumption per unit of water and high water quality. Because the moisture content of air in dry area is very low, the effect of direct condensation is limited. Solid adsorbent is able to adsorb water vapor from air at a low temperature and release water vapor at under high temperature, which can be used for water extracting from air. To improve its performance under dry circumstances, the key technical point of this device is to use solid adsorbent to collect water vapor from other air to raise its dew point temperature, and then use high temperature cold source to condense water vapor from it. In this paper, configurations of the solid adsorption are proposed, which can be driven with low regeneration temperature under the same humidity increasing amount. This device uses multi-stage desiccant wheels to realize humid increasing. Desiccant wheel can be driven with high temperature to take water vapor from dehumidification air and release water vapor to regeneration air. The multi-stage configuration is good for the reduction of regeneration temperature, making applications of low temperature waste heat form heat pumps possible. Then, influencing factors of water extracting rate are analyzed. The influencing of regeneration temperature, humid reduction amount of the humidified air and cooling and heating systems, etc., are analyzed. Last, air handling processes considering cold and heat sources are recommended to reduce energy consumption. The heat pump driven scenarios are discussed in particular. Through optimization, the water extracting rate can be increased and energy consumption per unit of water can be reduced. At present, this paper only studies air water extracting processes and thermal processes, and does not involve structure of the device, water purification and power consumption of fans, etc.

Moisture adjusting device

On-off Timing Computer Control System for Valved Refrigerator

Analysis of a Hybrid System of Adiabatic Absorption two-stage Liquid Desiccant and CO2 Transcritical Cycles

Optimum Control Strategy and Performance Simulation of a Constant Temperature and Humidity Air-conditioning System

Performance Study of a Constant Temperature and Humidity Air-Conditioning System with Temperature and Humidity Independent Control Device

A Novel Metal-Organic Frameworks Based Humidity Pump for Indoor Moisture Control

A Museum Storeroom Air-Conditioning System Employing the Temperature and Humidity Independent Control Device in the Cooling Coil

Air separation device working condition fluctuation repairing method

Performance Evaluations of Extracting Water From Dry Air Using Multi-Stage Desiccant Wheels and Vapor Compression Cycle

Research on working principle and realization mode of electronic controlled air dryer

Hollow Fiber Membrane Dehumidification Device for Air Conditioning System

Independent Humidity Control Air-Conditioning System Using Liquid Desiccant

Multi-stage internally-cooled membrane-based liquid desiccant dehumidifiers: Driving-force based insights into structural improvement

Household solid desiccant dehumidifier with multiple operating modes: Concept and prototype device

Research Progress in Liquid Desiccant Air-Conditioning Devices and Systems

Experimental investigation of a novel metal-organic framework (MOF) based humidity pump under high humidity conditions

Experimental and Numerical Investigation of a Novel Hybrid Deep-Dehumidification System Using Liquid Desiccant

Experimental Performance Investigation on a Desiccant-Assisted Two-Stage Evaporative Cooling System in Hot and Humid Areas

Additive reaction kettle vapour condensation device

A modeling study on a direct expansion based air conditioner having a two-sectioned cooling coil

Metal-Organic Frameworks as advanced moisture sorbents for energy-efficient high temperature cooling