Abstract:Objective Significant research and regulatory attention have been focused on the potential for some ultraviolet filters (UVFs) to rinse off from beachgoers' skin into seawater leading to exposure to sea life, especially coral reefs. The amount of UVFs potentially rinsed from skin during recreational beach activities has not been well‐studied, leading to uncertainty about the potential magnitude of aquatic UVF exposure due to changes in sunscreen use patterns. This study quantifies rinse‐off of UVFs in sunscreen from skin into synthetic seawater and identifies differences in rinse‐off quantity due to formulation type with a goal of informing future modeling efforts aimed at estimating UVF exposure to sea life associated with recreational activities at the beach. Methods UVF rinse‐off from skin during recreation in seawater was simulated by applying eight different sunscreen products to porcine skin samples followed by three periods of shaking in synthetic seawater totaling 40 minutes. The rinsed mass of six UVFs – zinc oxide, titanium dioxide, avobenzone, homosalate, octisalate, and octocrylene – was determined analytically in synthetic seawater and in extractant rinsate from glassware for organic UVFs and compared among formulas. Results Among the 22 UVF‐formulation combinations tested, 19 resulted in less than 10% of the applied UVF rinsed from skin. All formulation‐UVF combinations where the formula types were water‐in‐oil (reverse phase) emulsions or anhydrous resulted in 5% or less of the applied UVF rinsed to synthetic seawater. Sunscreens formulated as oil‐in‐water emulsions yielded higher rinse off percentages for all UVFs tested, with a maximum of 20% rinse‐off of avobenzone in one lotion. Conclusion The potential for sunscreen UVF rinse‐off is significantly influenced by formulation and is generally well below the prior assumed rinse‐off levels used to estimate risk. Formulation consideration is therefore essential for accurate exposure models used in environmental risk assessment. Anhydrous and reverse phase (water‐in‐oil) sunscreen formulations tested resulted in lower UVF transfer from skin to synthetic seawater in simulated ocean bathing tests and as a result, are expected to yield lower UVF exposures to sea life. This approach can be used in predictive environmental exposure models to support ecologically safe sunscreen formulation design.

Generalized Beer-Lambert law for evaluating the absorption of heterogeneous sunscreen films

Optics of sunscreen lotions: Preliminary results on scattering and absorption coefficients

Monte Carlo simulations of light transport in sunscreen formulations

Noninvasive measurement of the 308 nm LED-based UVB protection factor of sunscreens

Studies on Water Resistance of Sunscreens in Vitro

Sun-protection factor of zinc-oxide sunscreens: SPFin vitro too low compared to SPFin vivo-a brief review

Spectroscopic Analysis of Sun Protection Factor (spf) of Sunscreen Cosmetic

Influence of sunscreen formulation on the transfer of mineral and organic ultraviolet filters from skin to seawater in simulated ocean bathing tests

Development of Photoprotective Formulations: Influence of Formulation Composition on the SPF and Mechanical Properties

In vitro skin model for characterization of sunscreen substantivity upon perspiration

Computational Multiscale Study of the Interaction Between the PDMS Polymer and Sunscreen-Related Pollutant Molecules

Adaptability of polyurea microcapsules loaded with octyl salicylate for sunscreen application: influence of shell thickness of microfluidic-calibrated capsules on UV absorption efficiency

Accumulated p53 protein and UVA protection level of sunscreens

Contribution of Continued Dermal Exposure of PFAS-Containing Sunscreens to Internal Exposure: Extrapolation from In Vitro and In Vivo Tests to Physiologically Based Toxicokinetic Models

New insights into ESIPT mechanism of three sunscreen compounds in solution: A combined experimental and theoretical study

Understanding Formulation and Temperature Effects on Dermal Transport Kinetics by IVPT and Multiphysics Simulation

Structural Similarity-Induced Inter-Component Interaction in Silicone Polymer-Based Composite Sunscreen Film for Enhanced UV Protection

Percutaneous Absorption of Sunscreen Filters: Review of Issues and Challenges

Determining ultraviolet absorbents in sunscreen products by combining direct injection with micelle collapse on-line preconcentration capillary electrophoresis

Simultaneously regulating absorption capacities and antioxidant activities of four stilbene derivatives utilizing substitution effect: A theoretical and experimental study against UVB radiation

Comfortable skin sunscreens based on waterborne cross-linkable polydimethylsiloxane coatings