Abstract:The sustainable development of nuclear energy requires the extraction of uranium from uranium-containing wastewater. However, the selective separation process of uranium from mixed wastewater containing uranium has not been fully studied. This paper mainly verifies the feasibility of separating and recovering uranium from mixed uranium-containing waste liquid by electrodeposition. It also discusses the electrodeposition performance of a stainless-steel electrode on U(VI). Through carbonate pretreatment, the electrochemical method successfully achieved the selective separation and recovery of uranium in simulated wastewater. Visual MINTEQ software was used to calculate the retention rate and species of different ions in the solution after adding carbonate solution. The results showed that 99.4 % of the uranium in the mixed solution was retained as UO2(CO3)34- when the pH was higher than 10.0. The actual experimental results pointed out that the retention rate of uranium was 89.6 % in the mixed simulated wastewater with a pH of 10.0 +/- 0.05. And then the recovery of uranium could be achieved by the electrochemical method. When the pH value was higher than 10.0, 99.4 % of uranium in the mixed solution was retained in the form of UO2(CO3)34- . The retention rate of other metal ions in solution was less than 1 %. The results revealed that the carbonate pretreatment could selectively separate uranium and recover uranium by electrochemical method. Furthermore, the diffusion coefficients of UO2(CO3)34- at different temperatures were found to be linearly correlated with the square root of the scan rates, thus confirming that the reduction of U(VI) to U(V) is a diffusion-controlled process. Consequently, the electrodeposition rate could be greatly enhanced by the increase in temperature. The electrodeposition rate can be significantly enhanced when the potential is below -0.82 V. Uranium is electrodeposited in the form of multilayer films on the surface of stainless steel, as confirmed by SEM-EDS and XPS. Its composition is mainly U(IV) oxides or hydroxides. At 308.15 K, 99.97 % of the uranium could be recovered after 10 h electrodeposition at -1 V. Finally, the concentration of uranium in the simulated wastewater was reduced to 35 mu g/L. This method is expected to provide a new way to recover uranium from uranium containing wastewater produced by the nuclear industry.

Carbonate Pretreatment Combined with Electrodeposition to Selectively Extract Uranium from Mixed Wastewater

Uranium elimination and recovery from wastewater with ligand chelation-enhanced electrocoagulation

Efficient three-step strategy for reduction recovery of high purity uranium oxide from nuclear wastewater

Spontaneous electrochemical uranium extraction from wastewater with net electrical energy production

A reductive strategy with ultrahigh selectivity for sequential recovery of uranium from radioactive wastewater

Removal And Recovery Of Uranium From Groundwater Using Direct Electrochemical Reduction Method: Performance And Implications

Electrochemical deposition of uranium oxide with an electrocatalytically active electrode using double potential step technique

A non-polluting method for rapidly purifying uranium-containing wastewater and efficiently recovering uranium through electrochemical mineralization and oxidative roasting

Electrochemistry-assisted in-situ regeneration of oxygen vacancies and Ti(III) active sites for persistent uranium recovery at a low potential

Uranium electrolytic deposition with regenerable Se 2− active sites at low cell voltage

Microbial-driven ectopic uranium extraction with net electrical energy production

Efficient removal of uranium (VI) with a phytic acid-doped polypyrrole/ carbon felt electrode using double potential step technique

Nitrogen-doped carbon nanotube encapsulated Co 9 S 8 composite cathode for high-selective capacitive extraction of uranium (VI) from radioactive wastewater

Flexible Self-Standing Amidoxime-Functionalized Mxene Membrane for Electrochemical Uranium Extraction

Functionalized Iron–Nitrogen–Carbon Electrocatalyst Provides a Reversible Electron Transfer Platform for Efficient Uranium Extraction from Seawater

Uranium In Situ Electrolytic Deposition with a Reusable Functional Graphene‐Foam Electrode

Electrochemical Techniques for Uranium Extraction from Water

Weak electro-stimulation promotes microbial uranium removal: Efficacy and mechanisms

Precise Electrocatalysis on Fe‐Porphyrin Conjugated Networks Achieves Energy‐Efficient Extraction of Uranium

Highly Efficient Electrocatalytic Uranium Extraction from Seawater over an Amidoxime‐Functionalized In–N–C Catalyst

[Are rat alveolar macrophages capable of phagocytizing pollen grains?].