Abstract:In the vast inland areas of China, more than 3 million bridges have been built to connect the remote mountainous areas and also to make up the urban transportation networks. For these bridges, reinforced concrete is the most widely adopted material in construction. Unlike the offshore bridges subjected to chloride-induced corrosion, the inland bridges have been constantly threatened by atmospheric carbonation-induced corrosion. The inland areas of China are earthquake-prone regions where several major seismic events occurred in recent years. To investigate the seismic vulnerability of inland bridges subjected to atmospheric carbonation-induced corrosion, the time-dependent characteristics of carbonation were analyzed based on an illustrative cable-stayed bridge, and the time-dependent damage states of bridge components during earthquakes were identified through the material strains of reinforcing steel and concrete. A life-cycle fragility assessment method was proposed and was used to establish the time-dependent seismic fragility curves of the illustrative cable-stayed bridge at the component and system levels. Based on the time-dependent fragility analysis, the macro identification for the seismic damage to bridge system under each damage state and its influence on traffic and repair levels were discussed, the damage sequences of bridge components for different damage states were predicted, and the application strategies of the prediction for components' damage sequences at various service periods were introduced. The research shows that the stirrups tend to be corroded first, leading to rapid decreases of the characteristic strain values of the confined core concrete; and the longitudinal reinforcement experiences very slight corrosion during the bridge's service life. The atmospheric carbonation-induced corrosion increases significantly the damage probabilities of the various bridge components, and consequently change their damage sequences at different damage states. However, the carbonation-induced corrosion does not change the CDPs (complete damage points) and MDPs (maximum damage points) of various bridge components. The bridge system is vulnerable during earthquakes and significantly affected by material degradation. Within the design service life, the damage probabilities of the bridge system can be increased by 0.5620 by the carbonation-induced corrosion, the PGAs (peak ground accelerations) corresponding to CDPs can be decreased by 0.1 g, and the MDPs of the failure state can gradually convert to the CDPs. It is possible to predict the damage sequences of the bridge components during earthquakes on the basis of seismic fragility analysis for different service periods of the bridge, based on which the corresponding maintenance and retrofit strategies can then be determined to protect the bridge against possible earthquakes, and the costs can be reduced.

Combined Concrete and Cable Restrainers to Prevent Longitudinal Unseating of Highway Bridges During Earthquakes

A Method for Controlling Seismic Damage of RC Bridge Piers Subjected to Strong Aftershocks

Effectiveness of CFRP Seismic-Retrofit of Circular RC Bridge Piers under Vehicular Lateral Impact Loading

Remote Collaborative Pseudo-dynamic Testing of Carbon Fiber Reinforced Plastic Retrofitted Reinforcement Concrete Short Columns of Bridge

Experimental and numerical investigation on seismic performance of novel cable-restraining composite rubber bearings for highway bridges

SEISMIC RESPONSE ANALYSIS OF CABLE-STAYED BRIDGES USING CARBON FIBER COMPOSITE CABLE

SEISMIC DESIGN METHOD OF SMALL AND MEDIUM SPAN BRIDGE CONSIDERING BEARING FRICTION SLIPPING

Yielding Steel Dampers as Restraining Devices to Control Seismic Sliding of Laminated Rubber Bearings for Highway Bridges: Analytical and Experimental Study

Life-cycle seismic damage identification and components damage sequences prediction for cable-stayed bridge based on fragility analyses

Study on time-varying seismic vulnerability and analysis of ECC-RC composite piers using high strength reinforcement bars in offshore environment

Development of an Energy Dissipation Restrainer for Bridges Using a Steel Shear Panel

System-based probabilistic evaluation of longitudinal seismic control for a cable-stayed bridge with three super-tall towers

Seismic Responses and Damage Control of Long-Span Continuous Rigid-Frame Bridges Considering the Longitudinal Pounding Effect under Strong Ground Motions

Time-Progressive Dynamic Assessment of Abrupt Cable-Breakage Events on Cable-Stayed Bridges

Utilizing yielding steel dampers to mitigate transverse seismic irregularity of a multispan continuous bridge with unequal height piers

Strengthening of steel decks for cable-stayed bridge using ultra-high performance concrete: A case study

Experimental study on the post-tensioned unbonded prestressing UHPC prefabricated retaining blocks for highway bridges

Study on unseating prevention for multi-union long simply supported girder bridges under near-fault ground motions

Structural Assessment of Concrete Cable-Stayed Bridge after Replacement of Closure Segment: The Service Stage

Vehicular impact resistance of highway bridge with seismically-designed UHPC pier

Numerical Investigations on Seismic Behavior of Segmental Assembly of Concrete Filled Steel Tube Piers with External Replaceable Energy-Dissipating Links