Abstract:Structural Health Monitoring, Ahead of Print. Thermal integrity testing has been successfully used to assess the quality of cast-in-place piles for the past decade. It employs temperature data measured during concrete curing to identify defects along the piles' length. However, the uptake of this technology has been rather limited in the piling industry. The main concerns are that the method is not standardised and its reliability is not well understood. In order to address these, there are a number of fundamental questions that need to be explored in more detail, including (a) the optimum time to conduct the assessment, (b) the defect thermal impact, (c) the zone of influence on temperature sensors, (d) the minimum detectable size of a defect and (e) the associated optimum sensor location required. In this paper, experimental and numerical studies were conducted to examine these questions. Fibre optic sensors were employed on model concrete piles in laboratory tests to provide fully distributed temperature data throughout the curing process. The test results showed that the optimum time to assess the defects is approximately at 60% of the time to reach peak temperature and the minimal detectable defect size, using the currently available optical fibre sensor technology, is 4% of the cross-sectional area. In addition, the thermal influence of different defect sizes is presented. Following this, it is shown in the paper that the minimum numbers of sensor cables required to identify defects with cross-sectional areas of 4%, 5% and 8% are eight, six and four cables, respectively. The optimum layout of these sensor cables within a pile cross-section has also been discussed. When specifying pile instrumentation for integrity assessment, the findings of this paper enable practising engineers to make informed judgements in relation to the size of defects they would like to detect (and hence the associated risk this entails) together with the corresponding instrumentation layout required.

A Novel Method for Integrity Assessment of Soil-Nailing Works with Actively Heated Fiber-Optic Sensors

ANALYSIS ON SOIL-NAILED RETAINING STRUCTURE USING ENERGY METHOD

An Optical Fibre Monitoring System for Evaluating the Performance of a Soil Nailed Slope

Comparative Study on the Elongation Measurement of a Soil Nail Using Optical Lower Coherence Interferometry Method and FBG Method

DEVELOPMENT AND APPLICATION OF TWO TYPES OF OPTICAL FIBER SENSORS FOR MONITORING SOIL NAILS DURING PULL-OUT TESTING

Accuracy of Non-Destructive Estimation of Length of Soil Nails

FEM Analysis of Soil Nailing Support and Application of IT Monitoring in Construction

Slope Stability Analysis Based on Measured Strains along Soil Nails Using FBG Sensing Technology

A Novel Method of Embedding Distributed Optical Fiber Sensors for Structural Health Monitoring

Investigation of the evolutionary process of a reinforced model slope using a fiber-optic monitoring network

Sensitivity Analysis of the Factors Related to the Internal Stability of Soil Nailing

Critical height of soil nailing

Thermal integrity profiling of cast-in-situ piles in sand using fiber-optic distributed temperature sensing

Pile defect assessment using distributed temperature sensing: fundamental questions examined

Investigations on load-bearing behavior of soil nailing combined with flexible facing for slope stabilization

Distributed Optic Fiber Sensors for Soil Deformation Monitoring for Construction Method of Box Culverts Being Pushed to Replace Pipe Roofs

Soil Strain-Field and Stability Analysis of Cut Slope Based on Optical Fiber Measurement

AHFO-based Soil Water Content Sensing Technology Considering Soil–sensor Thermal Contact Resistance

Model Tests by Centrifuge of Soil Nail Reinforcements

Role of the interface between distributed fibre optic strain sensor and soil in ground deformation measurement

Implementation of a fibre optic monitoring system in a roadside slope in Hong Kong