Study on compressive-torsional behaviour of square concrete filled CFRP-steel tube (S-CF-CFRP-ST)
Kuan Peng,Qing-li Wang,Yong-bo Shao
DOI: https://doi.org/10.1016/j.oceaneng.2022.112217
IF: 5
2022-10-15
Ocean Engineering
Abstract:Concrete filled carbon fiber reinforced polymer confined steel tube (CF-CFRP-ST) columns are having promising utilization in offshore structures such as tower columns of offshore fans and curved beam bridges, which are usually subjected to the combination of axial compressive loading and torsional loading. To reveal the compressive-torsional behaviour of square concrete filled CFRP-steel tube (S-CF-CFRP-ST), total 8 specimens were designed and tested under compressive-torsional load. Principal factors of test are the confinement factor of transverse CFRP, strengthening factor of longitudinal CFRP, axial compression ratio and the compressive strength of cubic concrete as principal factors. Based on the tests, a numerical simulation method is firstly proposed to estimate the compressive-torsional performance of S-CF-CFRP-ST, and then validated against the representative tests results, such as the failure modes, torque-rotation angle curves, and torque-shear strain curves. The test results reveal that the CFRP sheets are all under tension during loading and can cooperate well with steel tube as strains measured on CFRPs. The failure mode of S-CF-CFRP-ST belongs to ductile failure. Additionally, the compressive-torsional deformation of S-CF-CFRP-ST is in line with plane section assumption before the specimen gets into plastic stage. The good consistence between numerical results and experimental ones reveals that the proposed simulation method can predict the torsional behaviour of S-CF-CFRP-ST reasonably and accurately. Using this verified numerical models, parametric study is conducted to explore the influence of principle factors (e.g. CFPR layers, strength of concrete and steel, and steel ratio) on compressive-torsional behaviour of S-CF-CFRP-ST. It is found that the compressive-torsional bearing capacity of S-CF-CFRP-ST is slightly improved with the increase of CFRP layers and significantly affected by the strength of the used square steel tube. Additionally, the increase of steel ratio for CF-CFRP-ST member enhances not only the torsional strength but also the initial stiffness. Finally, an expression for calculation of torsional bearing capacity of S-CF-CFRP-ST is proposed based on the result of test and numerical simulation.
engineering, civil, ocean, marine,oceanography