Abstract:The fluxes of sensible heat (H) and latent heat (LE), which are generally the important parts of the energy and mass balances over glacier surfaces, are widely quantified by the bulk method. However, due to the difficulty of determining the aerodynamic roughness length z(0m) in this method, H and LE values may still have large uncertainties with significant inaccuracy. To acquire reliable varying and intrinsic z(0m) values, new simpler parameterizations for z(0m) values at different ranges of the friction velocity u(*b) were fitted in this study. The method was implemented using the related meteorological data and glacial sublimation/condensation measured at the top of the August-one glacier (4817 m asl) in the Qilian Mountains from 1 July 2016 to 15 August 2017. The parameterization shows that z(0m) increased sharply when u(*b) exceeded 0.43 m/s (the approximate threshold value) and that the effect of snowdrift was slight for the hourly z(0m) values in the range 0.15 <= u(*b) <= 0.43 m/s, which could thus be used to calculate the daily z(0m). During the wet period (1 July to 24 September 2016 and 5 May to 15 August 2017), the turbulent fluxes calculated by the bulk method showed that net radiation R-net was the primary source of surface energy (60.7 w/m(2)), whereas during the dry period (25 September 2016 to 4 May 2017), the main heat sink was the positive H (28.5 w/m(2)) rather than the negative R-net (-10.0 w/m(2)). Plain Language Summary The profile method and the bulk method have been applied to quantify turbulent fluxes and sublimation/condensation, and the bulk method is more widely used because it is insensitive to observation errors. However, determination of the aerodynamic roughness lengths in the bulk method remains a large challenge. So we tried to acquire reliable varying and intrinsic roughness length for momentum through its parametric analysis. The related meteorological data and glacial sublimation/condensation were measured over a mountain glacier. Hourly roughness lengths in the transitional range affected slightly by snowdrift were found with the approximate threshold value. The comparison provided here verifies that these values are reliable, although this method is relatively rough. The z(0m) parameterization can be regarded as an important basis of turbulent heat flux research. Therefore, in addition to z(0m) parameterization, it can also be very meaningful to further discuss the temporal variation of meteorology and turbulent heat fluxes. Further research is needed and very important to improve our understanding of energy and mass exchange between the glacier surface and atmosphere, especially in arid and semiarid regions.

Data Files for JGR Paper "quantifying the Aerodynamic Roughness Length of Snow" by Junfeng Liu Et Al.

Quantifying the Aerodynamic Roughness Length of Snow Surfaces with Time‐Lapse Structure‐From‐Motion

Simple Parameterization of Aerodynamic Roughness Lengths and the Turbulent Heat Fluxes at the Top of Midlatitude August‐One Glacier, Qilian Mountains, China

Spatial and Temporal Variations in Glacier Aerodynamic Surface Roughness During the Melting Season, As Estimated at the August-one Ice Cap, Qilian Mountains, China

Spatial and Temporal Variations in Glacier Surface Roughness During Melting Season, As Observed at August-one Glacier, Qilian Mountains, China

Critical Evaluation of Scalar Roughness Length Parametrizations Over a Melting Valley Glacier

Variations in surface roughness of heterogeneous surfaces in the Nagqu area of the Tibetan Plateau

Deducing Aerodynamic Roughness Length From Abundant Anemometer Tower Data to Inform Wind Resource Modeling

A Modeling Study of the Tripole Pattern of East China Precipitation over the Past 425 Ka

Data for the Submission in JGR-OCEANS

Seasonal, Diurnal and Wind-Direction-Dependent Variations of the Aerodynamic Roughness Length in Two Typical Forest Ecosystems of China

ANALYSES OF SURFACE WINDS ALONG THE TRACK FROM ZHONGSHAN STATION TO DOME-A,ANTARCTICA

Analysis on Heterogeneous Underlying Surface Roughness Length in Semi-Arid Mountains Area of Loess Plateau, China

Palaeoclimate Simulations for the Late Cenozoic (from Mutz Et Al. 2018)

Global Aerodynamic Parameters in 1982-2017 Based on GLASS LAI (v1.1 Update to 2020)

Simulation and Statistical Analysis of Ground Snow Loads Based on a Multi-Layer Snow Accumulation and Melt Model

The Characteristics and Parameterization of Aerodynamic Roughness Length over Heterogeneous Surfaces

Supplementary Material to &quot;impact of Initialized Land Surface Temperature and Snowpack on Subseasonal to Seasonal Prediction Project, Phase I (LS4P-I): Organization and Experimental Design&quot;

EGUsphere-2023-998 Data and Code

A Study on Determining Aerodynamic Parameters over Gobi Desert Surface

A Snow Density Dataset for Improving Surface Boundary Conditions in Greenland Ice Sheet Firn Modeling