Abstract:The exchange flux of CO2 between the ocean and the atmosphere is an important indicator for studying the carbon cycle and the ocean acidification issue. The estimation of CO2 flux mainly depends on the detection of CO2 in seawater. As a widely used gas detection technology, Tunable Diode Laser Absorption Spectroscopy (TDLAS) has advantages in environmental adaptability, selectivity and good sensitivity, and thus it is potential in the in-situ detection for dissolved gas in seawater. In order to verify the feasibility of applying TDLAS technology to the in-situ detection for dissolved CO2 in the seawater, this paper integrates the permeable membrane which realizes gas-water separation with the TDLAS gas detection prototype developed in the laboratory to realize the in-situ detection for CO2 in seawater. The whole prototype is designed as a sealed cabin. The prototype' s material is aluminum alloy which has good tightness, pressure and corrosion resistance. The laser source uses a DFB laser with a central wavenumber of 4 990 cm(-1), and its wavenumber is scanned from 4 992 to 4 994. 5 cm(-1) over time, which can contain two absorption lines of CO2 at 4 992. 51 and 4 993. 74 cm(-1). The permeable membrane's material uses Teflon AF-2400 X with excellent pressure resistance and air permeability. Considering of requirements of high detection sensitivity and fast response rate for the prototype in underwater, the prototype uses a miniaturized Herriott-type multi-reflection cavity with good absorption characteristics. The cavity can achieve an effective optical path of 8 meters and a gas sampling volume of only 24 mL. A calibration experiment was done in the laboratory to reduce the influence of the prototype error on the measured value. Five different concentration (202. 8 x 10(-6), 503 x 10(-6), 802 x 10(-6) , 1 006 x 10(-6), 2 019 x 10(-6)) standard CO2 gases were measured by the prototype. The linear correlation (R-2) is 99. 95% between measured values, and actual values and the prototype has a maximum relatively error <= 8%. The prototype was used to continuously measure the standard CO2 gas with a concentration of 802 x 10(-6) for 30 minutes to evaluate the stability of the prototype for a long time working. The average measured value is 802. 6 x 10(-6), and the fluctuation range is only 10 x 10(-6). The accuracy of the prototype is about 0. 5%, which can fulfill the requirement of in-situ dissolved gas detection in seawater. A test was done in an offshore pier with a depth of 3 meters. The prototype successfully obtained the typical absorption spectrum and concentration results of dissolved CO2 in water for the whole 24 hours. The test verifies the long-lasting stability and robustness of the prototype. Through a shipborne adaptability test of five areas with different depths in the East China Sea, the typical absorption spectrum of dissolved CO2 was successfully obtained, which proved the adaptability of the TDLAS detection prototype combined with permeable membrane degassing technology within 30 meters depth of seawater.

Rapid and Real-Time Analysis of Multi-Component Dissolved Gas in Seawater by Raman Spectroscopy Combined with Continuous Gas-Liquid Separator

Underwater In Situ Dissolved Gas Detection Based on Multi-Reflection Raman Spectroscopy

Highly Sensitive Raman System for Dissolved Gas Analysis in Water

Real-time Analysis of Multicomponent Dissolved Inorganic Carbon in the Air-Sea Exchanging Process Using Gas-Liquid Raman Spectroscopy

Field Experimental Studies of Detecting the Dissolved CO2/HCO3- Using Raman Spectroscopy

Development of a Prototype for Dissolved CO2 Rapid Measurement and Preliminary Tests

Direct Measurement of Dissolved Gas Using a Tapered Single-Mode Silica Fiber

Development of a compact tunable diode laser absorption spectroscopy based system for continuous measurements of dissolved carbon dioxide in seawater

The Experimental Research on In-Situ Detection for Dissolved CO<sub>2</sub> in Seawater Based on Tunable Diode Laser Absorption Spectroscopy

[Raman Signal Enhancement for Gas Detection Using a Near Concentric Cavity].

Online Monitoring of Seawater Carbon Dioxide Based on an Infrared Rear Beam Splitter

High-Sensitivity and In Situ Multi-Component Detection of Gases Based on Multiple-Reflection-Cavity-Enhanced Raman Spectroscopy

A Fiber-Integrated CRDS Sensor for In-Situ Measurement of Dissolved Carbon Dioxide in Seawater

A High-Throughput Atomic Emission Analyzer for Simultaneous Field Detection of Dissolved Inorganic and Organic Carbon in Seawater and Lake Water.

A Portable Tunable Diode Laser Absorption Spectroscopy System for Dissolved CO2 Detection Using a High-Efficiency Headspace Equilibrator

On-line Multi-Component Analysis of Gases for Mud Logging Industry Using Data Driven Raman Spectroscopy

Development of a Compact Deep-Sea Raman Spectroscopy System and Direct Bicarbonate Detection in Sea Trials.

Online water vapor removal membrane inlet mass spectrometer for high-sensitivity detection of dissolved methane

Development of an Easy-to-Operate Underwater Raman System for Deep-Sea Cold Seep and Hydrothermal Vent In Situ Detection

Novel gas-tight multi-sampler for discrete deep-sea water

Cavity-enhanced Raman Spectroscopy for Simultaneous Detection of Characteristic Dissolved Gases in Oil