Abstract:Abstract Per recent analyses, in the near future, over half amount of the oil extracted globally, will require some form of enhanced oil recovery (EOR) techniques. Existing literature and historical investigations suggest that in oil reservoirs having viscosities between 10 – 150 m.Pa.s, there is a significant potential for tertiary recovery through the application of polymer flooding. For reservoir oil viscosities above 150 mPa.s, the polymer pumping efficiency goes down as polymer injectivity reduces significantly with increasing injection water viscosity that are used to attain a favorable mobility ratio at such high oil viscosities. To overcome this limiting factor, in this study, we propose the use of supramolecular assemblies (SMA) that have adjustable viscosity properties. Complexation of long-chain amino-amides and maleic acid is used to make these assemblies, which allow it to have reversible viscosity depending on the solution pH level. To maintain high injection efficiency, during pumping, SMA solutions will be kept at low viscosity values. On entry in deep reservoir or at oil contact phase, through introduction of an external stimulus the viscosity of SMA solution will be reversed to a much higher viscosity. This will allow to sufficiently improve the mobility ratio. Preliminary results from lab-scale studies have indicated that along with reversibly adjustable viscosity property, SMA solutions are also tolerant to high temperatures and salt concentrations. Supramolecular solutions can be considered as healable polymer systems, since unlike conventional polymer they disassemble and re-assemble when exposed to high temperature and stress conditions. In such conditions, conventional polymers generally undergo degradation. Additionally, through molecular scission processes SMA solutions can also be used in highly confining environments as well as in permafrost conditions and thin zones where conventional thermal techniques are not applicable. The objective of this work is the development of novel SMA system that have the aforementioned properties of reversibly adjustable viscosity through pH, tolerance to high temperature and salt concentrations through desired interfacial properties. Lab-scale preliminary results have shown the potential economic benefits of the use of SMA solutions on a field-wide scale. Based on the results, it must be emphasized that SMA systems have a worldwide application in oil reservoirs for EOR purposes.

Fluorinated Polyzwitterion Coatings for Stabilizing Colloids and Lowing Retention of Nanoparticles

Smart Nanoparticles for Conformance Improvement in Waterflooding

Nanoparticle-Assisted Surfactant/Polymer Formulations for Enhanced Oil Recovery in Sandstone Reservoirs: From Molecular Interaction to Field Application

Fabrication and evaluation of hydrophilic cross‐linked polystyrene nanoparticles as a potential in‐depth conformance control agent for low‐permeability reservoirs

Mechanism and Performance Analysis of Nanoparticle-Polymer Fluid for Enhanced Oil Recovery: A Review

High Salinity and High Temperature Stable Colloidal Silica Nanoparticles with Wettability Alteration Ability for EOR Applications

A Comprehensive Investigation of Nanocomposite Polymer Flooding at Reservoir Conditions: New Insights into Enhanced Oil Recovery

The comparison of interface properties on crude oil-water and rheological behavior of four polymeric nanofluids (nano-SiO2, nano-CaO, GO and CNT) in carbonates for enhanced oil recovery

Comprehensive experimental investigation of the effective parameters on stability of silica nanoparticles during low salinity water flooding with minimum scale deposition into sandstone reservoirs

Adsorption polymer on reservoir rock and role of the nanoparticles, clay and SiO2

The effect of nanoparticles on reservoir wettability alteration: a critical review

Potential application of novel Janus amphiphilic nanoparticles to improve the viscoelasticity of polymer solution for enhanced oil recovery

Effect of aluminium oxide nanoparticles on oilfield polyacrylamide: Rheology, interfacial tension, wettability and oil displacement studies

A high temperature resistance and hyper‐dispersed nanoparticle grafted by multi‐monomer via in‐situ polymerization: Preparation, characterization, and its imbibition performance

Optimizing synthesis and application of an enhanced oil recovery agent: stability assessment of the optimized nanostructured PNIPAM/PS core–shell polymer using a developed DLVO-based model

The Effect of Nano Heavy Metal Oxide Particles on the Wettability of Carbonate Reservoir Rock

Application of Polymer Brush-Shells on Nanoparticles for Controlling Interaction with Serum

Nanoparticles as foam stabilizer: Mechanism, control parameters and application in foam flooding for enhanced oil recovery

Synthesis and evaluation of depressurization and injection treatment agent suitable for low-permeability reservoirs

Facile route for processing natural polymers for the formulation of new low-cost hydrophobic protective hybrid coatings for carbon steel in petroleum industry

Experimental and Theoretical Investigation for Synthetic Polymers, Biopolymers and Polymeric Nanocomposites Application in Enhanced Oil Recovery Operations