Abstract:Dimethyl furan-2,5-dicarboxylate (DMFDCA) is a valuable biomass-derived chemical that is an ideal alternative to fossil-derived terephthalic acid as a monomer for polymers. The one-step oxidation of 5-hydroxymethylfurfural (HMF) to DMFDCA is of practical significance. It not only shortens the reaction pathway but also avoids the separation process of intermediates; thus, reducing cost. In this work, non-noble bimetallic catalysts supported on N-doped porous carbon (CoMn@NC) were synthesized via a one-step co-pyrolysis procedure using different pyrolysis temperatures and proportions of metal precursors and additives. We employed the prepared CoMn@NC catalysts in the aerobic oxidation of HMF under mild reaction conditions to obtain DMFDCA. High-yield DMFDCA was obtained by screening the prepared catalysts and optimizing the reaction conditions, including the strength and amount of the base, as well as the reaction temperature. The optimized yield of DMFDCA was 85% over the Co3Mn2@NC-800 catalyst after 12 h at 50 degrees C using ambient-pressure oxygen. The physicochemical properties of the catalysts were determined using a variety of characterization techniques, the factors affecting the performance of each catalyst were investigated, and the relationship between the physicochemical properties and performance of the prepared catalysts was elucidated. A porous structure with a high surface area had a positive effect on mass transfer efficiency. Cobalt nanoparticles (NPs) and atomically dispersed Mn were coordinated to N-doped carbon to form M-N-x (where M = Co or Mn). Based on the Mott-Schottky effect, there was significant electron transfer between each metal and the N-doped carbon, additionally, the metal NPs supplied electrons to the carbon atoms. The electron-deficient metal site in the pyridinic N-rich carbon was beneficial for the activation of HMF and oxygen. The activation of oxygen produced reactive oxygen species (such as superoxide radical anions) to ensure high selectivity to DMFDCAthrough dehydrogenative oxidation of the hemiacetal intermediate and hydroxymethyl group of 5-hydroxymethyl-2-methyl-furoate. The existence of disordered and defective carbons increased the number of active sites. Subsequently, we performed a series of control experiments. Based on our current experimental results and previous studies, we propose a simple mechanism for the aerobic oxidation of HMF to DMFDCA. The catalyst was stable, its performance decreased slightly after two cycles, and it was tolerant to SCN - ions and resistant against N or S poisoning. Furthermore, the use of this catalytic system can be expanded to various substituted aromatic alcohols, such as benzyl alcohols with different substituents, furfuryl alcohol, and heterocyclic alcohols. Simultaneously, the product type was further extended from methyl esters to ethyl esters with a high yield when the substrate reacted with ethanol. In conclusion, this catalytic system can be applied in the production of carboxylic esters for polymers.

Photoswitchable Catalytic Aerobic Oxidation of Biomass-Based Furfural: A Selective Route for the Synthesis of 5-Hydroxy-2(5h)-furanone and Maleic Acid by Using the CdS/MOF Photocatalyst

Liquid-Phase Aerobic Oxidation of 5-Hydroxymethylfurfural to 2,5-Furandicarboxylic Acid over Co/Mn/Br Catalyst

Structural Designs and Mechanism Insights into Electrocatalytic Oxidation of 5-Hydroxymethylfurfural

Selective Hydrogenation of Furfural to Furfuryl Alcohol Without External Hydrogen over N-doped Carbon Confined Co Catalysts

Selective Oxidation of Furfural to 2(5H)-Furanone and Maleic Acid over CuMoO 4

Construction of Electron Transport Channels and Oxygen Adsorption Sites to Modulate Reactive Oxygen Species for Photocatalytic Selective Oxidation of 5-Hydroxymethylfurfural to 2,5-Diformylfuran

Photocatalytic selective oxidation of biomass-derived 5-hydroxymethylfurfural to 2,5-diformylfuran under ambient conditions over CdIn2S4/g-C3N4 heterojunctions

Combining Electro-, Photo-, and Biocatalysis for One-Pot Selective Conversion of Furfural into Value-Added C4 Chemicals

Aerobic Oxidation of 5-Hydroxymethylfurfural to Dimethyl Furan-2,5- Dicarboxylate over CoMn@NC Catalysts Using Atmospheric Oxygen

Mechanistic Studies on the Photooxidation of 5‐Hydroxymethylfurfural by Polyoxometalate Catalysts and Atmospheric Oxygen

Production of the 2,5-Furandicarboxylic Acid Bio-Monomer From 5-Hydroxymethylfurfural Over a Molybdenum-Vanadium Oxide Catalyst

Visible-light-driven anaerobic oxidative upgrading of biomass-derived HMF for co-production of DFF and H2 over 1D Cd0.7Zn0.3S/NiSe2 Schottky junction

Photocatalytic Partial Oxidation of 5-Hydroxymethylfurfural (HMF) to 2,5-Diformylfuran (DFF) over a Covalent Triazine Framework in Water

Research Progress on Photocatalytic, Electrocatalytic and Photoelectrocatalytic Selectively Oxidation of 5-Hydroxymethylfurfural

Selective Oxidation of Furfural in a Bi-Phasic System with Homogeneous Acid Catalyst

Optimization of 5-hydroxymethylfurfural oxidation via photo-enzymatic cascade process

Customizing the synergy of reactive oxygen species and photoactive charges on Bi2O2CO3/ZnIn2S4 for the selective photooxidation transformation of 5-hydroxymethylfurfural

Elucidation of Active Sites and Mechanistic Pathways of a Heteropolyacid/Cu-Metal–Organic Framework Catalyst for Selective Oxidation of 5-Hydroxymethylfurfural via Ex Situ X-ray Absorption Spectroscopy and In Situ Attenuated Total Reflection-Infrared Studies

A Switchable Selective Catalytic Hydrogenation of Furfural over MOF-Supported Ru-Based Catalysts Based on Reaction Atmosphere Regulation

Boosting The Electrochemical 5‐Hydroxymethylfurfural Oxidation by Balancing The Competitive Adsorption of Organic And OH− Over Controllable Reconstructed Ni3S2/NiOx

Highly Selective Photocatalytic Oxidation Biomass Valorization over Nb 2 O 5 / G ‐C 3 N 4 Heterojunction