Abstract:Significance: Forces inside cells play a fundamental role in tissue growth, affecting important processes such as cancer cell migration or tissue repair after injury. Förster resonance energy transfer (FRET)-based tension sensors are a remarkable tool for studying these forces and should be made easier to use. Aim: We prove that absolute FRET efficiency can be measured on a simple setup, an order of magnitude more cost-effective than a standard FRET microscopy setup, by applying it to vinculin tension sensors (VinTS) at the focal adhesions of live CHO-K1 cells. Approach: Our setup located at Université Paris-Saclay acquires donor and acceptor fluorescence in parallel on two low-cost CMOS cameras and uses two LEDs for rapid switching of the excitation wavelength at a reduced cost. The calibration required to extract FRET efficiency was achieved using a single construct (TSMod). FRET efficiencies were measured for VinTS and the tail-less control VinTL, lacking the actin-binding domain of vinculin. Measurements were confirmed on the same cell type using a more standard intensity-based setup located at Rutgers University. Results: The average FRET efficiency of VinTS (22.0%±4%) over more than 10,000 focal adhesions is significantly lower (p<10-6) than that of VinTL (30.4%±5%), our control that is insensitive to force, in agreement with the force exerted on vinculin at focal adhesions. Attachment of the CHO-K1 cells on fibronectin decreases FRET efficiency, thus increasing the force, compared with poly-lysine. FRET efficiency for the VinTL control is consistent with all measurements currently available in the literature, confirming the validity of our measurements and hence of our simpler setup. Conclusions: Force measurements, resolved spatially inside a cell, can be achieved using FRET-based tension sensors with a cost effective intensity-based setup. This will facilitate combining FRET with techniques for applying controlled forces such as optical tweezers.

Quantum dot-based FRET nanosensors for Talin-membrane assembly and mechanosensing

Quantum Dot-based biosensors for protein assembly and mechanosensing

Protease Sensing Using Nontoxic Silicon Quantum Dots

Fluorescence Biomembrane Force Probe: Concurrent Quantitation of Receptor-ligand Kinetics and Binding-induced Intracellular Signaling on a Single Cell

Quantum-Enhanced Diamond Molecular Tension Microscopy for Quantifying Cellular Forces

Quantitative and Multiplexed Fluorescence Lifetime Imaging of Intercellular Tensile Forces

A pair of FRET dyes designed to measure nano-scale contact and the associated adhesion force

Optical Single Molecule Spectroscopy for Monitoring Conformational Dynamics of a Single Biomacromolecule

Förster resonance energy transfer efficiency measurements on vinculin tension sensors at focal adhesions using a simple and cost-effective setup

In-Silico Analyses of Molecular Force Sensors for Mechanical Characterization of Biological Systems

Quantum dot-based fluorescence resonance energy transfer with improved FRET efficiency in capillary flows.

Traction Force Microscopy with DNA FluoroCubes

Carbon-nanotube field-effect transistors for resolving single-molecule aptamer–ligand binding kinetics

Quantifying T cell receptor mechanics at membrane junctions using DNA origami tension sensors

FRET-Sensing of Multivalent Protein Binding at the Interface of Biomimetic Microparticles Functionalized with Fluorescent Glycolipids

Detecting Sequential Bond Formation Using Three-Dimensional Thermal Fluctuation Analysis.

Fluorescence Lifetime-Based DNA Probe for Multiplexed Quantification of Tensile Forces at Cell-Cell Junctions

Quantifying Tensile Forces at Cell–Cell Junctions with a DNA-based Fluorescent Probe

Unimolecular FRET sensors: Simple linker designs and properties

Molecular Sensing and Manipulation of Protein Oligomerization in Membrane Nanotubes with Bolaamphiphilic Foldamers