Leaching Behavior and Risk Assessment of Per- and Polyfluoroalkyl Substances in Typical Fluoropolymers

Lingyi Meng,Ruiqi Wan,Hao Hu,Dan Wu,Ziliang Yang,Jie He,Guilan Lu,Jinzhong Yang,Yufei Yang,Qifei Huang
DOI: https://doi.org/10.1021/acsestwater.3c00681
2024-01-01
ACS ES&T Water
Abstract:Per- and polyfluoroalkyl substances (PFAS) are commonly used as emulsifiers in fluoropolymer production. PFAS have higher water solubility than other persistent organic pollutants; therefore, their behavior in water must be carefully considered. At present, however, data on the leaching behavior of PFAS, especially those in fluoropolymers, are limited. Here, PFAS in 10 typical fluoropolymer materials were quantitatively analyzed, and the total PFAS concentrations ranged from 1.6 to 5.4 x 10(3) ng/g. Perfluorooctanoic acid (PFOA) was the dominant PFAS (90 +/- 15%). The leaching rates of PFOA in four simulated leaching solutions were 34 +/- 43% (landfill leachate), 33 +/- 31% (acid rain), 39 +/- 28% (surface water), and 46 +/- 38% (seawater). For most fluoropolymer samples, the leaching rate of PFOA increased with increasing pH. The dilution attenuation factor (DAF) of PFOA was calculated using the Environmental Protection Agency's composite model for leachate migration with transformation products (EPACMTP), and a value of 1/DAF = 131 (applicable to China) was obtained. Approximately 10-20% of the calculated risk quotients based on the Chinese benchmark were higher than 1, indicating a high risk. Therefore, the release of PFAS into the environment from fluoropolymers is of concern.
What problem does this paper attempt to address?