Abstract:Pressure drop (Δp) and collection efficiency (η) are used to evaluate the separation performance of the cyclone separator. In this study, we conducted comparative study of cyclone models using response surface methodology (RSM), back propagation neural network (BPNN), and group method of data handling (GMDH) networks to develop optimal predictive cyclone models. Also, we conducted multi-objective optimization for maximizing model and minimizing model using genetic algorithm (GA). CFD was performed instead of experimental method to get the estimated values for modeling of Δp and η. The validation results of CFD showed 0.5% and 2% errors for Δp and η, respectively, compared with the experimental data. Second, design of experiment (DOE) analysis for 10 cyclone geometrical parameters was executed to obtain the significant geometrical parameters. Vortex finder diameter Dx, inlet width a, inlet height b and cone height Hco have a significant effect on η and Δp. However, interaction effects between the geometrical parameters have small effects. The cyclone models by RSM, BPNN and GMDH based on 25 CFD training set were developed. The predictive performance results by the cyclone models were compared by 25 CFD test set. The GMDH method achieved the best prediction for Δp (R2=99.7, RMSE = 0.102) Radjusted2=98.99, RMSE = 0.0119) than the RSM, BPNN cyclone models. Additionally, uncertainty analysis was performed to estimate the quantitative performance of cyclone models. The results show that the uncertainty width of GMDH models achieved the best prediction (η: ±0.0065, Δp: ±0.0188). Finally, GA was applied to optimize the GMDH models simultaneously. GA generated 70 non-dominant solutions. Reproducibility of five optimal points was validated by using CFD. The trade-off optimal point showed improvement by 24.31%, 18% and 8.79% for Δp d50 and η, respectively.

Parametric Design of Curved Hydrocyclone and Its Optimization Based on Artificial Neural Networks Prediction

Parametric Design of Curved Hydrocyclone Using Data Points and Its Separation Enhancement Mechanism

Research on structural parameter optimization of a new axial inlet hydrocyclone separator based on response surface optimization method

Predictive Modeling of the Performance of the Hydrocyclone with Different Cone Combination

Multi-objective optimization and comparison of surrogate models for separation performances of cyclone separator based on CFD, RSM, GMDH-neural network, back propagation-ANN and genetic algorithm

Numerical Modelling and Multi-Objective Optimization of the Novel Hydrocyclone for Ultra-Fine Particles Classification

Design of Cyclone Separator Critical Diameter Model Based on Machine Learning and CFD

Experimental study of the separation performance of a hydrocyclone with a compound curve cone

Effect of cone section combination form on the separation performance of a biconical hydrocyclone

Artificial neural network for the performance improvement of a centrifugal pump

Geometrical configuration of hydrocyclone for improving the separation performance

Numerical investigation of hydrocyclone inlet configurations for improving separation performance

Optimization of the Structural Parameters of a Cyclone by Using a Genetic Algorithm

Machine learning based design optimization of centrifugal impellers

Multi-objective Optimization of a Low Specific Speed Centrifugal Pump Using an Evolutionary Algorithm

Optimization of a Centrifugal Pump to Improve Hydraulic Efficiency and Reduce Hydro-Induced Vibration

Study on Performance of a New Configuration of Circumfluent Hydrocyclone

Performance analysis of a novel cyclone separator using RBFNN and MOPSO algorithms

Design of an Axial Hydrocyclone for Preliminary Water Separation Using CFD, RSM, and SUS

Experimental Investigation of Various Inlet Section Angles in Mini-Hydrocyclones Using Particle Imaging Velocimetry

Numerical Study on the Relationship Between High Sharpness and Configurations of the Vortex Finder of a Hydrocyclone by Central Composite Design