Abstract:In this study, the process of carbon dioxide (CO2) capture directly from ambient air in a conventional monoethanolamine (MEA) absorption process was simulated and optimized using a rate-based model in Aspen Plus. The process aimed to capture a specific amount (148.25 Nm3/h) of CO2 from the air, which was determined by a potential application aiming to produce synthetic methane from the output of a 2.7 MW electrolyser (593 Nm3/h H2). We investigated the technical performance of the process by conducting a sensitivity analysis around different parameters such as air humidity, capture rate defined as a ratio of moles of CO2 captured during the process to the total mole of CO2 in the feed stream, CO2 loading of lean and rich absorption liquids and reboiler temperature, and evaluated the energy consumption and overall cost in this system. In order to meet the design requirement for standard packed columns, the rich absorption liquid was circulated to the top of the absorber. A capture rate of 50% was selected in this process as a baseline. At higher capture rates, the required energy per ton of captured CO2 increases due to a higher steam stripping rate, required in the desorber, and at lower capture rates, the size of equipment, in particular, absorber and blowers increases due to the need for processing a significantly larger volume of air at the given CO2 production volume. At the base case scenario, a reboiler duty of 10.7 GJ/tCO2 and an electrical energy requirement of 1.4 MWh/tCO2 were obtained. The absorber diameter and height obtained were 10.4 and 4.4 m, respectively. The desorber is found to be relatively small at 0.54 m in diameter and 3.0 m in height. A wash water section installed at top of the absorber decreased the MEA loss to 0.28 kg/ton CO2. However, this increased capital cost by around 60% resulting in CO2 capture costs of $1,691 per ton CO2 for the MEA base scenario. Based on the techno-economic analysis, assuming a non-volatile absorbent rather than MEA thereby avoiding a wash water section, and using an absorption column built from cheaper materials, the estimated cost per ton of CO2 produced was reduced to $676/tCO2. The overall cost range was between $273 and $1,227 per ton of CO2 depending on different economic parameters such as electricity ($20–$200/MWh) and heat price ($2–$20/GJ), plant life (15–25 years) and capital expenditure (±30%). In order to reduce the cost further, the use of innovative cheap gas-liquid contactors that operate at lower liquid to gas ratios is crucial.

Modeling and Comparative Analysis of CO2 Absorption Columns in Electrochemical and Thermochemical Carbon Capture Systems

Rate-Based Modelling and Validation of an Absorber and Stripper in an Amine-Based Post-Combustion CO2 Capture Process

A Comparative Study of Different Sorbents in the Context of Direct Air Capture (DAC): Evaluation of Key Performance Indicators and Comparisons

Comparative Assessment of Amine-Based Absorption and Calcium Looping Techniques for Optimizing Energy Efficiency in Post-Combustion Carbon Capture

Experimental Study of the Dynamic Behavior of the Stripping Column for Post-combustion CO2 Capture with Monoethanolamine

Techno-Economic Assessment for CO2 Capture From Air Using a Conventional Liquid-Based Absorption Process

Cost-effective carbon-based amine adsorbents for carbon capture: Equilibrium, kinetics and selectivity

Impact of thermodynamics and kinetics on the carbon capture performance of the amine-based CO2 capture system

Electrochemical CO2 capture thermodynamics

A thermodynamic approach to energy requirements for CO 2 capture and a comparison between the minimum energy for liquid and solid sorbent processes

Insights into Energetic Penalties in Electrochemical CO2 Separation Systems

Performance Simulations of Mea/Nh3 Based Large-Scale Co2 Capture in Packed Columns under Different Flue Gas Parameters

Development of a Chemistry-Based Isotherm Model and Techno-Economic Optimization of a Moving Bed Process for CO 2 Capture Using a Functionalized Metal-Organic Framework

Post-combustion CO2 capturing by KOH solution: An experimental and statistical optimization modeling study

Evaluating Solvent Efficiency for Carbon Capture: Comparative Analysis of Temperature, Concentration and Diffusivity Effects

Electrochemical reduction of CO2 in the captured state using aqueous or nonaqueous amines

Systematic study of aqueous monoethanolamine‐based CO2 capture process: model development and process improvement

Performance of industrially implemented turbulent contact absorbers – a comparative study

Energy minimization in monoethanolamine‐based CO2 capture using capacitive deionization

Assessment of carbon dioxide separation by amine solutions using electrolyte non-random two-liquid and Peng-Robinson models: Carbon dioxide absorption efficiency

Sensitivity Analysis of Post Combustion Carbon Capture Using Monoethanolamine (MEA) as a Solvent. A Simulation Study