Abstract:2.5D advanced packaging technology is a promising solution for “more than Moore”. TGV interposer has attracted growing attention for the high-frequency applications in 2.5D advanced packaging due to its low dielectric constant and loss tangent, etc. Some typical failure modes of TGV structure were discussed in the previous literatures. However, there is a lack of systematic research on the failure mechanisms of TGV under annealing and thermal shock condition. This paper focused on the failure mechanisms of TGV under different thermal conditions using both experimental and simulation methods. Annealing experiment was carried on the TGV sample at 400 °C for different periods. Crack appeared in the glass at the top corner of TGV after annealed at 400 °C for 5 min. With the increasing annealing period from 5 min to 30 min at 400 °C, the protrusion height of TGV increased from $0.61\ \mu\mathrm{m}$ to $1.21\ \mu \mathrm{m}$ , and the simulated protrusion height increased from $0.50\ \mu \mathrm{m}$ to $0.89\ \mu \mathrm{m}$ . The FEA simulation result showed that stress concentration was located in the top corner of TGV, the stress was 1456.63 MPa at 400 °C for 5 min. TGV samples were subjected to 0, 300, 500 and 1000 cycles under the condition of $-55\ ^{\circ}\mathrm{C}$ to 150 °C. Glass will crack around TGV-RDL after 300 thermal shock cycles. The stress was found concentrated around TGV-RDL according to FEA, which was 370.34 MPa. Crack appeared at the bottom corner of the TGV after 1000 cycles. The equivalent plastic strain at the bottom corner of TGV increased from 1.09 to 3.64 with the cycles increased from 300 to 1000. This article analyzes failure mechanisms of TGV and provides design guidelines for the pretreatment process of TGV. The simulation result offers information for the reliability evaluation of TGV.

Reliability Study of Through Glass Vias under High Current Density

Thermo-Mechanical Reliability Study of Through Glass Vias in 3D Interconnection

The electromigration failure mechanism for TSV process

Performance and reliability study of TGV interposer in 3D integration

Exploration and Analysis of Through-Glass Vias for High-Speed, Low-Loss Vertical Interconnects in Glass-Based 3-D Integrated Circuits

Failure Mechanisms Investigation of Through Glass Via (TGV) under Thermal Annealing and Shock

Reliability study of through-silicon via (TSV) copper filled interconnects

Comparison of the Time-Dependent Physical Processes in the Electromigration of Deep Submicron Copper and Aluminum Interconnects

Design of Compact and Low-Emi Waveguide Structures Based on Through Glass Vias

Thermo-Mechanical Reliability of Micro-joints in a RF Packaging with Through Glass Via (TGV) Interposer

Design and Modeling of Non-Uniform Through-Glass Vias and Its Optimization Methods

Mechanical Reliability Testing of Air-Gap Through-Silicon Vias

Finite Element Analysis Of Electromigration Reliability In Copper Chip Interconnect

Parasitic RLGC Properties of High-density Through-Glass Via

Experimental and Numerical Studies of Stress Migration in Cu Interconnects Embedded in Different Dielectrics

Metallization Reliability of GaN-Based High-Voltage Light-Emitting Diodes

Thermal and Electrical Reliability Tests of Air-Gap Through-Silicon Vias

Microwave evaluation of electromigration susceptibility in advanced interconnects

Reservoir Effect and the Role of Low Current Density Regions on Electromigration Lifetimes in Copper Interconnects

Reliable Design of Electroplated Copper Through Silicon Vias