Abstract:The cryptomelane-type manganese oxide (OMS-2)-supported Co (xCo/OMS-2; x = 5, 10, and 15 wt.%) catalysts were prepared via a pre-incorporation route. The as-prepared materials were used as catalysts for catalytic oxidation of toluene (2000 ppmV). Physical and chemical properties of the catalysts were measured using the X-ray diffraction (XRD), Fourier transform infrared spectroscopic (FT-IR), scanning electron microscopic (SEM), X-ray photoelectron spectroscopy (XPS), and hydrogen temperature-programmed reduction (H2-TPR) techniques. Among all of the catalysts, 10Co/OMS-2 performed the best, with the T90%, specific reaction rate at 245°C, and turnover frequency at 245°C (TOFCo) being 245°C, 1.23 × 10-3 moltoluene/(gcat·sec), and 11.58 × 10-3 sec-1 for toluene oxidation at a space velocity of 60,000 mL/(g·hr), respectively. The excellent catalytic performance of 10Co/OMS-2 were due to more oxygen vacancies, enhanced redox ability and oxygen mobility, and strong synergistic effect between Co species and OMS-2 support. Moreover, in the presence of poisoning gases CO2, SO2 or NH3, the activity of 10Co/OMS-2 decreased for the carbonate, sulfate and ammonia species covered the active sites and oxygen vacancies, respectively. After the activation treatment, the catalytic activity was partly recovered. The good low-temperature reducibility of 10Co/OMS-2 could also facilitate the redox process accompanied by the consecutive electron transfer between the adsorbed O2 and the cobalt or manganese ions. In the oxidation process of toluene, the benzoic and aldehydic intermediates were first generated, which were further oxidized to the benzoate intermediate that were eventually converted into H2O and CO2.

Preparation of Cobalt Catalyst Supported on Perovskite-type Oxide and Application in Liquid Phase Selective Oxidation Reaction

Highly Catalytic Performance for the Selective C-H Bond Oxidation of P-Chlorotoluene over Co, Cr Co-Doped OMS-2 Catalyst

Rational Design of Nitrogen and Carbon Co-Decorated Mesoporous TiO2 Composites for Photocatalytic Selective Oxidation of Alcohols

Catalytic Oxidation of Styrene and Its Reaction Mechanism Consideration over Bimetal Modified Phosphotungstates

Cobalt Single Atoms on Tetrapyridomacrocyclic Support for Efficient Peroxymonosulfate Activation.

Synthesis of Titanium Silicon Composite Oxide Supported Cobalt Oxide Catalyst and Its Catalytic Performance for p ‐ Diethylbenzene Oxidation

Direct activation of PMS by highly dispersed amorphous CoOx clusters in anatase TiO2 nanosheets for efficient oxidation of biomass-derived alcohols

Effects of support for cobalt catalysts in catalytic oxidation of toluene

Promotional effect of cobalt doping on catalytic performance of cryptomelane-type manganese oxide in toluene oxidation

Preparation of Co<sub>3</sub>O<sub>4</sub>Catalysts by a Solid-state Reaction for Total Oxidation of Toluene

Efficient CO Oxidation by Co/Ta2O5 Prepared by Deposition–Precipitation with Urea

Synthesis and characterization of perovskite-supported CoNi catalyst for CO oxidation via exsolution

Preparation of Co_3O_4 Catalysts by a Solid-state Reaction for Total Oxidation of Toluene

Pd-Co Based Spinel Oxides Derived from Pd Nanoparticles Immobilized on Layered Double Hydroxides for Toluene Combustion

Dual-active sites of Co and oxygen vacancy in Co-doped CeO2 catalyzed toluene oxidation for consequent Knoevenagel condensation

Engineering Cobalt Oxide with Coexisting Cobalt Defects and Oxygen Vacancies for Enhanced Catalytic Oxidation of Toluene

Bamboo-like MnO2⋅Co3O4: High-performance catalysts for the oxidative removal of toluene

Mesoporous nickel-cobalt oxide for efficient liquid-phase benzyl alcohol oxidation by air

Efficient CO catalytic oxidation by the combination of cobalt and excellent carrier Ta2O5

Selective liquid phase oxidation of toluene with air