Abstract:A new tannic acid -based adsorbent (cyclotriphosphazene crosslinked tannic acid, TAH) for effective and selective removal of cationic dyes from aqueous solution was facilely synthesized employing rigid molecule hexacyclotriphosphazene (HCCP) as cross -linker at room temperature. The resulting typical sample TAH-3 was spherical with mean size of about 480 nm. Using cationic methylene blue (MB) as target dye, the adsorption property of TAH-3 was assessed systematically by investigating the effects of various key factors on the MB removal, including solution pH, adsorption time, con -existing ions, initial dye concentration and temperature. The experimental results showed that at 298.15 K and an initial MB concentration of 150 mg/L, the adsorption capacities of TAH-3 for MB ranged from 510 to 562 mg g -1 across a wide pH range of 3 to 10. The adsorption rate was very swift, and 72 % of equilibrium adsorption amount could be achieved within the initial 30 min. The effect of different valence co -existing ions on MB adsorption was quite different. The addition of monovalent Na + could promote the MB adsorption, while the introduction of high -valence Ca 2+ and Al 3+ could inhibit the MB adsorption. After five adsorption - desorption cycles, TAH-3 presented a small loss in adsorption capacity for MB and maintained good structural stability. The remarkable adsorption of MB on TAH-3 might arise from the synergistic contribution of ion exchange, electrostatic attraction, H -bonding and 7L -7L interaction. In addition, the TAH-3 spherical adsorbent could separate MB dye from binary mixed solution polluted by MB and anionic dye with a relative separation factor ranging from 281 to 11556. This work offers a facile and cost-effective synthetic route for negatively charged TA -based spherical adsorbent with high adsorption capacity and swift adsorption rate for cationic dye over a wide solution pH range.

One-step Room Temperature Synthesis of Cyclotriphosphazene Crosslinked Tannic Acid Spherical Adsorbent for Efficient Removal of Cationic Dyes in a Wide Ph Range

One-step crosslinking preparation of tannic acid particles for the adsorption and separation of cationic dyes

Facile Synthesis of Silver Bromide-Based Nanomaterials and Their Efficient and Rapid Selective Adsorption Mechanisms Toward Anionic Dyes

Facile Preparation of Tannic Acid-Poly(vinyl alcohol)/Sodium Alginate Hydrogel Beads for Methylene Blue Removal from Simulated Solution

Removal of methylene blue from coloured effluents by adsorption onto SBA-15

One-Step Synthesis of Recyclable Ti-Doped Porous SiO2 Microspheres with Superior Structural Stability for Cationic Dye Adsorption

A Cyclic Titanium-Oxo Cluster with a Tetrathiafulvalene Connector as a Precursor for Highly Efficient Adsorbent of Cationic Dyes

Carbonized titanium dioxide with good adsorption properties for cationic dyes via simple heat treatment

Hollow polyphosphazene microcapsule with rigid-flexible coupling cationic skeletons for highly efficient and selective adsorption of anionic dyes from water

Adsorption Behavior and Mechanism of Acid Orange 7 and Methylene Blue on Self-Assembled Three-Dimensional MgAl Layered Double Hydroxide: Experimental and DFT Investigation

β-Cyclodextrin network crosslinked by novel phosphonium-based tetrakiscarboxylic acid derived from PH3 tail gas: Synthesis and application for rapid removal of organic dyes from wastewater

Efficient Removal of Cationic Dye by Biomimetic Amorphous Calcium Carbonate: Behavior and Mechanisms

High porosity cyclotriphosphazene-based hyper-crosslinked polymers as efficient cationic dye MB adsorbents

Facile Synthesis of Sustainable Tannin/Sodium Alginate Composite Hydrogel Beads for Efficient Removal of Methylene Blue

Black wattle tannin‐immobilized mesostructured collagen as a promising adsorbent for cationic organic dyes (methylene blue) removal in batch and continuous fixed‐bed systems

Removal of Methylene Blue from Aqueous Solution Using Chitosan-G-poly(acrylic Acid)/montmorillonite Superadsorbent Nanocomposite

Green Synthesis of 2-Hydroxypropyl-/3-cyclodextrin Polymers Crosslinked by Citric Acid for Highly Efficient Removal of Methylene Blue

Adsorption properties of methylene blue and Cu(II) on magnetically oxidized tannic acid cross-linked carboxymethyl chitosan gels

Mesoporous polymetallic silicate derived from naturally abundant mixed clay: A potential robust adsorbent for removal of cationic dye and antibiotic

Synthesis of poly(hexachlorocyclotriphosphazene-co-phenolphthalein) microspheres with negative charges for the selective removal of cationic dyes

Preparation of Sulfonate-Grafted Tetraphenylethylene-Based Hyper-Cross-Linked Polymers for Efficient Adsorption of Organic Dyes in Aqueous Solutions