Abstract:Grid-forming (GFM) technologies based on converters or synchronous machines (SMs) were proposed as emerging approaches for improving inertia, damping, and strength of power girds with increasing renewable energy penetration. Although the stability of GFM converters has been widely studied, the dynamics of a grid-connected generator can be dictated by the bulk power systems. Therefore, the stability of islanded microgrids with hybrid GFM sources should be investigated. To fulfill this gap, this paper adopts a general component connection method for modelling islanded microgrids integrated with multiple generators, and models for SMs, grid-following (GFL) and GFM converters are developed. Additionally, a new GFM technology known as the motor-generator pair (MGP) is investigated, and the model for small signal analysis is derived. Then, full-order state-space models for nine scenarios with hybrid GFM sources as well as simulation models which are used to verify their effectiveness are built. Finally, small-signal dynamics of different scenarios are fully examined. In the scenarios with SMs integrated, the range of oscillation frequency is wider than all converter-based scenarios, and mechanical dynamics can dominate stability; and in scenarios with only GFM converters, though the damping can be improved compared to GFL converters, low frequency oscillation may occur, and the dominant factor changes from the phase locked loop and power controller to voltage controller; then improvement in damping can be observed in MGP-based scenarios, but roots that dominate stability are sensitive to current controller and excitation. Further, critical ranges for control parameters, GFM converter penetration and electrical distance in different scenarios are investigated.

On the Destabilizing Mechanism of Nonuniform Damping in Grid-Forming Converters Penetrated Multi-Machine System

Large-disturbance Stability for Power-Converter-dominated Microgrid: A Review

Transient Stability Analysis and Coordination Control Design for Grid-Forming PMSG Based on Dynamics of DC-Link Capacitor

Online Damping Monitoring Approach Based on Disturbances of Traction Load and Its Application

Transient Stability Analysis of Grid Forming Converters Based on Damping Energy Visualization and Geometry Approximation

Terminal Voltage Dynamics Analysis and Stability Assessment of Gird Forming Converters with the Impact of Grid Current Feedforward Control

Analysis of Stability Stationary Point for Virtual Parameters of Grid-forming Converter Integrated Power Systems Based on Small-signal Model

Transient Synchronization Stability Modeling and Analysis of Grid-Following Converter Considering Current Dynamics

Effect of Doubly Fed Induction GeneratorTidal Current Turbines on Stability of a Distribution Grid under Unbalanced Voltage Conditions

Hybrid Frequency-Domain Modeling and Stability Analysis for Power Systems with Grid-Following and Grid-Forming Converters

Small Disturbance Stability Analysis of Weak-Grid-Connected DFIG-Based Wind Power System

Transient Stability Analysis of Grid-Following Converters with DC-Link Voltage Control Considering Bidirectional Power Flow

Stability Analysis of Grid-Forming Inverter Considering Different Operating Points

Impedance Modeling and Stability Mechanism Analysis for Grid Forming and Grid Following Converters

Dynamic Interaction Analysis and Damping Control Strategy of Hybrid System with Grid-forming and Grid-following Control Modes

Interaction Between Grid-Forming Converters with AC Grids and Damping Improvement Based on Loop Shaping

A Hybrid Energy and Mode Decomposition-Based Method for Evaluating Generators Damping in Multi-Machine Power Systems

On the stabilizing contribution of different grid‐forming controls to power systems

Power Coupling and Stability Analysis of GFM Due to Rotational Frames and Control Loops Interaction

Analysis of the Stability and System Participation Factors of Grid-Connected Converters

Modelling and small signal stability for islanded microgrids with hybrid grid-forming sources based on converters and synchronous machines