Enhanced Broadband Mid-Infrared Emission in Dy3+/Er3+:LiYF4 Single Crystal Through Multi-Doping with Lu3+ and Gd3+ Ions

Lizhi Fang,Xiong Zhou,Haiping Xia,Hongwei Song,Baojiu Chen
DOI: https://doi.org/10.1016/j.jre.2024.03.001
IF: 4.632
2024-01-01
Journal of Rare Earths
Abstract:A series of Dy3+/Er3+ co-doped LiYF4 single crystals with enhanced broadband mid-infrared luminescence was successfully prepared using the Bridgman technique by introducing Lu3+ and Gd3+ ions. The impact of non-active Lu3+ and Gd3+ ions on the crystallographic structure and optical properties of the single crystal was examined through X-ray diffractions, Rietveld refinements, absorption spectra, emission spectra, and fluorescence decay curves. The 1.55 μm near-infrared luminescence exhibits a monotonic decrease upon the introduction of Lu3+ and Gd3+ ions. In contrast, the mid-infrared (2.9 μm) emission intensities in 0.5Dy3+/0.5Er3+/3.0Lu3+, 0.5Dy3+/0.5Er3+/3.0Lu3+/0.5Gd3+: LiYF4 single crystals are dramatically enhanced, showing increases of 5.8 and 9.8 times, respectively, compared to the co-doped samples. The maximum emission cross section of 2.9 μm for the 0.5Dy3+/0.5Er3+/3.0Lu3+/0.5Gd3+:LiYF4 single crystal was calculated to be around 4.4 × 10−20 cm2, exhibiting a significant improvement. Several plausible reasons for the effects of Lu3+/Gd3+ doping on luminescence are proposed. The competitive occupancy of Lu3+/Gd3+ doped ions at the lattice sites of Y3+ ions leads to lattice distortion and alteration of the local crystal field symmetry due to the difference in ionic radii, promoting the breaking of 4f forbidden transitions for Dy3+/Er3+ ions and enhancing the radiation transition between Dy3+ and Er3+ ions, meanwhile, the number of luminescent centers increased, which can be ascribed to the dissociation of possible [Er3+-Er3+] and [Dy3+-Dy3+] clusters, heightening energy transfer efficiency from Dy3+ to Er3+. The Dy3+/Er3+/Lu3+/Gd3+ multi-doped LiYF4 single crystal with broadened and enhanced 2.9 μm emission spectrum is a promising potential material for advanced applications in MIR solid-state and broadband tunable lasers.
What problem does this paper attempt to address?