Abstract:Improving the contamination resistance of membranes is one of the most effective ways to address the short service life of membranes. While preparing the membrane system structure, doping nanoparticles into the polymer matrix is beneficial to the preparation of high-performance membranes. To develop a new structure for membrane contamination protection, in this study, a novel asymmetric polyamide 66 composite ultrafiltration (UF) membrane was fabricated by incorporating different masses (ranging from zero to 0.5 wt.%) of graphene oxide (GO) into the polyamide 66 microporous substrate, using formic acid and propylene carbonate as solvents. The effects of GO doping on the morphology, microporous structure and surface of ultrafiltration membranes were investigated by atomic force microscopy (AFM), scanning electron microscopy (SEM), integrated thermal analysis (DSC) and contact angle (CA). In addition, pure water flux, bovine serum albumin (BSA) rejection and contamination resistance were measured to evaluate the filtration performance of different membranes. The overall performance of all the modified membranes was improved compared to pure membranes. The results of contact angle and permeation experiments showed that the addition of GO improved the hydrophilicity of the membrane, but reduced the permeability of the membrane. The minimum flux was only 3.5 L/m2·h, but the rejection rate was 92.5%. Most noteworthy was the fact that GO further enhanced the anti-pollution performance of the membranes and achieved a remarkable performance of 91.32% when the GO content was 0.5 wt.%, which was 1.36 times higher than that of the pure membrane. Therefore, optimal performance was achieved. Furthermore, the UF membrane made of composite substrate offers a promising solution for the development of long-life ultrafiltration membranes with better stability, high-cost efficiency and adequate chemical durability.

Polyphenol-mediated Defect Patching of Graphene Oxide Membranes for Sulfonamide Contaminants Removal and Fouling Control.

Graphene Oxide Based Membrane Intercalated by Nanoparticles for High Performance Nanofiltration Application

Enhancing the Dye-Rejection Efficiencies and Stability of Graphene Oxide-Based Nanofiltration Membranes via Divalent Cation Intercalation and Mild Reduction

“Mix-Then-On-Demand-Complex”: In Situ Cascade Anionization and Complexation of Graphene Oxide for High-Performance Nanofiltration Membranes

Azido-group Functionalized Graphene Oxide/polysulfone Mixed Matrix Ultrafiltration Membrane with Enhanced Interfacial Compatibility for Efficient Water and Wastewater Treatment

Graphene Oxide-Based Membranes Intercalated with an Aromatic Crosslinker for Low-Pressure Nanofiltration

Functionalised graphene oxide-based nanofiltration membranes with enhanced molecular separation performance

Enhancing H2O2 Tolerance and Separation Performance through the Modification of the Polyamide Layer of a Thin-Film Composite Nanofiltration Membrane by Using Graphene Oxide

Shielding Membrane Surface Carboxyl Groups by Covalent-Binding Graphene Oxide to Improve Anti-Fouling Property and the Simultaneous Promotion of Flux

Graphene oxide modified membrane for highly efficient wastewater treatment by dynamic combination of nanofiltration and catalysis

Improving Permeability and Fouling Resistance of GO Hydrophilic/hydrophobic Janus Membrane by Polyether Amine Crosslinking for Membrane Distillation of Dye Wastewater

Graphene Oxide Modified Polyamide 66 Ultrafiltration Membranes with Enhanced Anti-Fouling Performance

Effect of TiO2 Content on the Properties of Polysulfone Nanofiltration Membranes Modified with a Layer of TiO2–graphene Oxide

Bio-inspired Fabrication of Anti-fouling and Stability of Nanofiltration Membranes with a Poly(dopamine)/Graphene Oxide Interlayer

Selective Ion Permeation through Stabilized Metal–Phenolic Grafted Graphene Oxide Membranes

One-step enhancement of solvent transport, stability and photocatalytic properties of graphene oxide/polyimide membranes with multifunctional cross-linkers

Preparation of fouling resistant and highly perm-selective novel PSf/GO-vanillin nanofiltration membrane for efficient water purification

A facile graphene oxide modified approach towards membrane with prominent improved permeability and antifouling performance

A mild one-step method to fabricate graphene oxide cross-linked with dopamine/polyethyleneimine (GO@DA/PEI) composite membranes with an ultrahigh flux for heavy metal ion removal

Regulating the surface properties and interlamellar spacing of GO-based nanofiltration membrane for efficient water treatment

A Membrane with Strong Resistance to Organic and Biological Fouling Using Graphene Oxide and D-Tyrosine as Modifiers