Abstract:Partial discharge measurement plays an important role in the assessment of insulation status and fault diagnosis of power equipment. Presently, the most commonly used industrial applications of PD detections are based on the broadband measurement systems that count amplified PD pulses. The limitations of these traditional measurements are that the system requires a relatively high sampling rate and calculation capability, and is very sensitive to the ambient noise. To eliminate noise interference and save the cost of PD detection system, a technique measurement of excess currents, which measures the dielectric response currents through test object before and after PD activities to capture the activities of PD, has been reported in some recent studies. This work aims to explore the parameters that characterize the PD activities via excess current technology and to seek new ideas for PD detection. In this work, a measurement setup for measurement of PD excess currents averaged from 300 periods is applied and three typical insulation defect models were tested under 50Hz voltages. Excess currents for each case are measured. Then the corresponding dielectric loss factors and circuit impedances are obtained by comparing them to the synchronous voltages. The results show that the loss factors increase after PD while the circuit impedances decrease. Meanwhile, the loss factors continue to increase and the circuit impedances continue to decrease as the voltages turn up where the rate of the change shows more rapid in the needle-plate model. Moreover, the loss factors and circuit impedances in the dielectric barrier model and air void model are respectively higher and lower than the values before PD when the voltages drop below the PD extinction voltages, which does not appear in the needle-plate model. These characteristics provide a new idea for PD detection by monitoring the loss factors or circuit impedances via excess current detection.

Optical Detection and Characteristics of PCB Partial Discharge in More-electric Aircraft under Square Wave Voltage

Optical Detection Method for Partial Discharge of Printed Circuit Boards in Electrified Aircraft under Various Pressures and Voltages

Surface Discharge Detection and Severity Assessment of Printed Circuit Boards for Electric Aircraft Using Fluorescent Fiber

Effects of Low Pressure Condition on Partial Discharges in WBG Power Electronics Modules

Negative Medium-Voltage Direct Current Discharges in Air under Simulated Sub-Atmospheric Pressures for All-Electric Aircraft

Partial Discharge Development in Needle-Plane Configuration of Oil-Paper Insulation under AC Voltage

Partial Discharge Detection in Gas-Insulated Switchgears Using Sensors Integrated with UHF and Optical Sensing Methods

Dielectric Loss Factor and Circuit Impedance under Partial Discharge Via Excess Current Detection

A Novel Approach to Partial Discharge Detection Under Repetitive Unipolar Impulsive Voltage

Quantitative Analysis of Electrical Tree Growth with Partial Discharge Characteristics of PCB Double Layer under AC Voltage

Temperature‐dependent partial discharge characteristics of high temperature materials at DC voltage for hybrid propulsion systems

Partial Discharge Detection and Assessment of Surface defects under Fast Rising Repetitive Square Voltage for MV Converter Application

Partial Discharge Characteristics on Pressboard Surface under Different DC Polarities

Electrical Treeing and Partial Discharges in Double Layer Printed Circuit Board

Study on the Combined Characteristics of UHF and Optical Signals Induced by Partial Discharge at Spacer Surface in GIS

Effect of Different Coating Materials on Partial Discharge Characteristics and Electrical Tree of Printed Circuit Board

Optical Sensing Technology for Acoustic Detection of Partial Discharges: A Review

Experimental Investigation of Transient Earth Voltage and Acoustic Emission Measurements of Partial Discharge Signals in Medium-Voltage Switchgears

Partial Discharge Ultrasonic Detection Based on Sagnac Optical Interference Technique

Measurement and Analysis of Partial Discharge on Floating Electrode Defect in GIS

Multispectral Optical Partial Discharge Detection, Recognition, and Assessment