Analysis and Monitoring of Hydrogen Accidents of Fuel Cell Vehicles in Container Transportation

Cheng Bi,Hong Lv,Cunman Zhang
DOI: https://doi.org/10.1007/978-981-99-8585-2_10
2024-01-01
Abstract:In overland transportation, containers are convenient for short-haul transportation of small quantities between OEMs, distributors and customers. However, there is no systematic hydrogen safety research in container transportation, which makes the regulations not completely suitable for FCVs. This study will focus on various scenarios of hydrogen accidents in FCVs in different types of standard containers. A 1CC type of standard container is taken as an example, and an FCV loaded with 140 L of 70 MPa hydrogen is placed in it. In the process of hydrogen leakage and diffusion, hydrogen will gradually spread from the leak to the whole container in 130s. Even under the condition of the lowest hydrogen loading (20 bar), the final hydrogen volume fraction in the container will reach about 9.6%, which exceeds the lower limit of hydrogen flammability. Therefore, there is a potential for combustion and explosion in the container. If a larger volume container is used, the safety threshold for hydrogen loading can be increased accordingly. Additionally, when ignition happens beside the left rear wheel, the difference in the moment of ignition will affect the consequences of deflagration. The detection points by the side of container walls will pick up the temperature change in 0.4s at the earliest, while the pressure does not produce a very large sudden change. It indicates that the deflagration of hydrogen in the container is sufficient but not violent. In the case of ignition after 60s of full diffusion of hydrogen, the highest pressure inside the container is able to reach 3.15 bar at 3s after ignition and the highest temperature can reach 1094.8 K. However, it should be noted that the pressure and temperature will be overestimated in the container deflagration simulation. Thus, the results in this study can be used as a more conservative reference value for hydrogen safety in containers.
What problem does this paper attempt to address?