Numerical Study on the Unusual Vibration Load Characteristics and Mechanisms of the Front Landing Gear Compartment

Huixue Dang,Jiang Xu,Wei Wang,Xiaochen Wang,Bin Li,Ruizhi Cao,Liuhong Kang,Zhichun Yang

DOI: https://doi.org/10.3390/aerospace10120999

IF: 2.66

2023-01-01

Aerospace

Abstract:Civilian aircraft can experience noticeable vibrations in the cockpit and cabin due to mechanical faults during flight. To address this issue, a hybrid approach was utilized to investigate fluid-induced vibration load characteristics in the front landing gear compartment under different hatch opening angles. The results reveal that the root mean square (RMS) of cumulative pressure loads on both small and large hatches under different opening angles is largest at a 15°. For all the simulated cases (0°, 5°, 10°, 15°, 20°), the power spectral density (PSD) results of the chosen monitoring points on the inner wall of the large hatch exhibit broadband frequency characteristics, and the peak PSD values for the chosen monitoring points on the outer wall of the small hatch exhibit a significant concentration of energy at approximately 75 Hz. The peak PSD values for the selected monitoring points on the inner wall of the small hatch demonstrate a more uniform distribution of energy. Utilizing the iso-surface of Q-criterion, spatial streamlines, and streamlines at different cross-sections to analyze flow characteristics, the study investigates the fluctuating load mechanisms of the compartments. The results indicate that unsteady loads stem from the blunt edges of the hatches, which induce unsteady flow and spanwise flow. Geometric gaps between different locations cause flow separation, and the flows inside the compartment exhibit characteristics similar to those of a clean cavity. Furthermore, the mutual interference can be described using circulating flow and spanwise flow, resulting in flow unsteadiness. The flow separation zones enlarge and vortex intensity increases with the increase of the hatch opening angle from 0° to 15°; then, their values decrease as the hatch opening angle increases from 15° to 20°. These variations explain the maximum RMS of cumulative pressure loads at 15°.