Abstract:Cellulose is attracting attention for the development of environmentally friendly, carbon-neutral, sustainable materials. Cellulose derivatives with cationic groups have the potential for applications in various fields, e.g., electrolytes. However, the current situation is marked by a low degree of cationic group incorporation and a need for more efficient synthesis methods. In this study, cationic cellulose was synthesized using an epoxy derivative, 2,3-epoxypropyltrimethylammonium chloride (EPTMAC), in an aqueous pyrrolidinium hydroxide solution. Since an aqueous pyrrolidinium hydroxide solution is a strong alkaline solution, the solution not only exhibits a high cellulose solubility at room temperature but also facilitates the reaction between cellulose and the epoxy derivative. We investigated the influence of reaction time, temperature, cellulose concentration, cationic reagent concentration, and the selection of a precipitation solvent for purification on the degree of substitution (DS) value of cationic cellulose. The structure of the obtained cationic cellulose was examined using 1H NMR, 1H-1H TOCSY, 1H-13C HSQC measurements, and Fourier-transform infrared spectroscopy (FT-IR). As a result of increasing cellulose and EPTMAC concentrations, the DS value increased, reaching a maximum value of 1.9. Solubility tests indicated that the cationic cellulose with chloride counter-anions exhibited notable solubility even in ethanol when the DS values were over 1.2. Cationic cellulose with bis(trifluoromethylsulfonyl)amide (TFSA) anion synthesized with a view to battery applications was insoluble in water and exhibited a film-forming property. Thus, the solubility of cationic cellulose could be controlled by varying the anionic species.

What problem does this paper attempt to address?

The main problem that this paper attempts to solve is to increase the Degree of Substitution (DS) value of cationic cellulose. The DS value of cationic cellulose obtained by traditional synthesis methods is relatively low (usually between 0.2 and 0.6), which limits its performance in many applications. To overcome this problem, the author proposes a new synthesis method, using hydrated N - butyl - N - methylpyrrolidinium hydroxide ([C₄mpyr][OH]/H₂O) solution as a solvent and 2,3 - epoxypropyltrimethylammonium chloride (EPTMAC) as a reaction reagent to synthesize cationic cellulose with a high DS value. Specifically, the author achieves this goal by optimizing the following parameters: 1. **Reaction time**: The influence of different reaction times on the DS value was studied, and it was found that the reaction was basically completed within 10 minutes. 2. **Reaction temperature**: The change in DS value at different temperatures was investigated, and it was found that the DS value was the highest at room temperature (about 25 °C). 3. **Cellulose concentration**: The influence of different cellulose concentrations on the DS value was studied, and it was found that a cellulose concentration of 15 wt% was optimal. 4. **EPTMAC dosage**: The influence of different EPTMAC molar equivalents on the DS value was explored, and it was found that as the EPTMAC dosage increased, the DS value increased significantly, reaching a maximum of 1.9. 5. **Selection of precipitation solvent**: The influence of different precipitation solvents on the DS value was studied, and it was found that 2 - propanol was the optimal precipitation solvent. Through these optimizations, the author successfully increased the DS value of cationic cellulose to 1.9, significantly exceeding the maximum value (about 0.6) that can be achieved by traditional methods. In addition, the author also characterized the synthesized cationic cellulose by means such as nuclear magnetic resonance (NMR) and Fourier transform infrared spectroscopy (FT - IR), and tested its solubility in different solvents to further verify its structure and performance.

Rapid synthesis of cationic cellulose with high degree of substitution values over 1.0 in aqueous pyrrolidinium hydroxide solutions

Facile Cellulose Dissolution and Characterization in the Newly Synthesized 1,3-Diallyl-2-ethylimidazolium Acetate Ionic Liquid

Novel Diacid-superbase Ionic Liquids for Efficient Dissolving Cellulose and Simultaneous Preparation of Multifunctional Cellulose Materials

Synthesis of cationic hemicellulosic derivatives with a low degree of substitution in dimethyl sulfoxide media

Cationically modified 6-deoxy-6-azido cellulose as a water-soluble and reactive biopolymer derivative

Synthesis of N-oxyethylene substituted imidazolium-based zwitterions as a recyclable solvent for cellulose dissolution

The impact of acetylation on physical and electrochemical characteristics of cellulose-based quasi-solid polymer electrolytes

Synthesis of Highly Polymerized Water-soluble Cellulose Acetate by the Side Reaction in Carboxylate Ionic Liquid 1-ethyl-3-methylimidazolium Acetate

Preparation and dielectric properties of cellulose derivatives with high‐polarity substituents

Application of Eco-Friendly Cationic Celluloses for Effective Sludge Dewatering

Optimizing crystal transitions in low-temperature, low-concentration NaOH solutions to prepare cellulose I and II composite materials

Reactive Deep Eutectic Solvent for an Eco-Friendly Synthesis of Cellulose Carbamate

Synthesis, characterization and properties of novel cellulose derivatives containing phosphorus: cellulose diphenyl phosphate and its mixed esters

Cellulose modified to host functionalities via facile cation exchange approach

Efficient Cellulose Dissolution and Film Formation Enabled by Superbase Amino Acid Ionic Liquids

Green synthesis of cellulose graft copolymers for anion exchange water purification

Cellulose dissolution and regeneration using a non-aqueous, non-stoichiometric protic ionic liquid system

Innovative Green Synthesis of Hydrophobic Covalent Networks Using Ethyl Cellulose/Thymol Eutectic Systems

Propylene Carbonate Based‐Organic Electrolytes for Cellulose Dissolution Processing and Derivatization

The synthesis of multifunctional cellulose graft alternating copolymers of 3,4-dihydrocoumarin and epoxides in DBU/DMSO/CO 2 solvent system

Customising Sustainable Bio-Based Polyelectrolytes: Introduction of Charged and Hydrophobic Groups in Cellulose