Abstract:This article presents a fully differential high-dynamic-range direct-conversion receiver for sub-1-GHz band applications in a 180-nm CMOS technology. The integrated self-adaptive multipart automatic gain control (AGC) loops are designed to cope with large input signal. In the radio frequency (RF) domain, a gain-adjustable noise-canceling balun low-noise amplifier (LNA) and a high-linearity RF variable gain amplifier (VGA) are co-designed to keep a steady differential output power for the mixer stage. In baseband (BB), a novel gain distribution method is proposed to protect BB circuits from saturation. To prove the concept, one of the most typical and strict application scenarios in the sub-1-GHz band, digital television (DTV) standard, is analyzed and chosen as the design target. The receiver achieves a noise figure (NF) of 3.6–4.6 dB in the ultrahigh-frequency (UHF) band. A wide gain tuning range of 128.8 dB is realized in this work, featuring fully integrated AGC loops. The programmable bandwidth of the low-pass filter (LPF) can be adjusted from 1 to 4 MHz, supporting 2-/6-/7-/8-MHz signal channels. The maximum in-band third-order input-referred intercept point (IIP3) is 10 dBm under the conversion gain of 0 dB. The receiver consumes 49.56 mA from a 1.8-V voltage supply and occupies an area of 3.56 mm2.

A Reconfigurable Analog Base Band Circuit Used in Wide Band System

A Reconfigurable Analog Baseband Circuit for Wlan, Wcdma, and Bluetooth

A 1.8-V, 5-Ma Reconfigurable Analog Baseband Circuit for Low-if Multi-Mode Multi-Band Receivers

A 115-325MHz Wideband Analog Baseband with 0.5dB-Step Variable Gain Amplifier and Six-order Reconfigurable Gm-C Lowpass Filter.

A Sub-1-GHz Band High-Dynamic-Range Receiver with Integrated Self-Adaptive Multipart AGC Loops

Highly Reconfigurable Analog Baseband for Multistandard Wireless Receivers in 65-nm CMOS

A reconfigurable analog baseband for low-power Wi-Fi receiver

Analysis and Design of Ultra-Wideband Low-Noise Amplifier with Input/Output Bandwidth Optimization and Single-Ended/Differential-Input Reconfigurability.

Flexible analog baseband for WiMedia MB-OFDM and China UWB standard

A 256mhz Analog Baseband Chain with Tunable Bandwidth and Gain for UWB Receivers

An LP/CBP reconfigurable analog baseband circuit for software-defined radio receivers in 65 nm CMOS.

A Baseband Lpf for Gsm, Td-Scdma and Wcdma Multi-Mode Transmitters

A Reconfigurable Analog Baseband for Ka Band Transmitter

Analog baseband for WCDMA implementation by using digital-controlled DC Offset Cancellation

Reconfigurable Low Pass Filter with Automatic Frequency Tuning for WCDMA and GSM Application.

A 1.2GHz bandwidth and 88 dB gain range analog baseband for multi-standard 60 GHz applications

A Wide Tuning Range Low-Pass Gm-C Filter for Multi-Mode Wireless Receivers with Automatic Frequency Calibration

Widely reconfigurable 8th-order chebyshev analog baseband IC with proposed push-pull op-amp for Software-Defined Radio in 65nm CMOS

A Low-Power Reconfigurable Multi-Band Sliding-If Transceiver For Wban Hubs In 0.18 Mu M Cmos

A Low Power Analog Baseband for IoT Applications in 40 Nm CMOS

A Reconfigurable Low Power Filter in 65 nm CMOS for Multi-standard Transmitters