Abstract:PURPOSE: Valgus high tibial osteotomy (HTO) and a recently introduced extra-articular absorber have been shown to efficiently unload the medial compartment of the knee. However, only little is known about the influence of these treatment modalities on biomechanics of the patellofemoral joint. The purpose of this study was to investigate and compare the impact of different HTO techniques and implantation of an extra-articular absorber on patellofemoral contact forces.METHODS: Fourteen fresh frozen cadaveric knees were tested in a specially designed knee simulator that allowed simulation of isokinetic flexion-extension motions under physiological loading. Mean contact pressure (ACP) and peak contact pressure (PCP) of the patellofemoral joint was measured continuously between 0° and 120° of knee flexion using a pressure sensitive film in the following conditions: native, after biplanar medial open-wedge HTO with 5° and 10° correction angle performing an ascending frontal osteotomy of the tibial tuberosity, and after implantation of an extra-articular absorber system (KineSpring®). Including a second testing cycle with a biplanar medial open-wedge HTO with 5° and 10° correction angle performing descending frontal osteotomy of the tibial tuberosity. Values after each procedure were compared to the corresponding values of the native knee.RESULTS: Biplanar proximal osteotomy leaded to a significant increase of retropatellar compartment area contact pressure compared to the first untreated test cycle (Δ 0.04 ± 0.01 MPa, p = 0.04). Similar results were observed measuring peak contact pressure (Δ 1.41 ± 0.15 MPa, p = 0.03). With greater correction angle 5°, respectively, 10° peak and contact pressure increased accordingly. In contrast, the biplanar distal osteotomy group showed significant decrease of pressure values (p = 0.004). The extracapsular, extra-articular absorber had no significant influence on pressure levels in the patellofemoral joint.CONCLUSION: HTO with a proximal biplanar osteotomy of the tuberositas tibia significantly increased patellofemoral pressure conditions depending on the correction angle. In contrast a distally directed biplanar osteotomy diminished these effects while implantation of an extracapsular, extra-articular absorber had no influence on the patellofemoral compartment at all. Consequently, patients with varus alignment with additional retropatellar chondropathia should be treated with a distally adverted osteotomy to avoid further undesirable pressure elevation in the patellofemoral joint.

Eliminating Impingement Optimizes Patellar Biomechanics in High Knee Flexion.

In Vitro Kinematic Measurements of the Patellar Tendon in Two Different Types of Posterior-Stabilized Total Knee Arthroplasties

Clinical and Computational Evaluation of an Anatomic Patellar Component

Pericardial effusion associated with rhinovirus infection in an immunocompetent infant.

Optimizing the patellofemoral compartment in total knee arthroplasty: Is it time for dynamic assessment?

Excessive flexed position of the femoral component causes abnormal kinematics and joint contact/ ligament forces in total knee arthroplasty

High tibial osteotomy increases patellofemoral pressure if adverted proximal, while open-wedge HTO with distal biplanar osteotomy discharges the patellofemoral joint: different open-wedge high tibial osteotomies compared to an extra-articular unloading device

Lateral Release With Tibial Tuberosity Transfer Alters Patellofemoral Biomechanics Promoting Multidirectional Patellar Instability

In Vivo Kinematics of the Extensor Mechanism of the Knee During Deep Flexion.

Biomechanical Lower Limb Model to Predict Patellar Position Alteration after Medial Open Wedge High Tibial Osteotomy

Load-Dependent Characteristics of Cruciate-Retaining and Posterior-Stabilized Total Knee Arthroplasty: A Biomechanical Study

Adjusting Insert Thickness and Tibial Slope Do Not Correct Internal Tibial Rotation Loss Caused by PCL Resection: In Vitro Study of a Medial Constraint TKA Implanted with Unrestricted Calipered Kinematic Alignment

Retention of the posterior cruciate ligament stabilizes the medial femoral condyle during kneeling using a tibial insert with ball-in-socket medial conformity

[Attempted evaluation of the risk of contamination of very young children (0 to 4-years-old) raised in tuberculous environments, based on the study of familial records of several clinics of the Paris region].

Patellofemoral contact patterns before and after total knee arthroplasty: an in vitro measurement

A New Methodology for the Accurate Measurement of Tibiofemoral Kinematics in Human Cadaveric Knees: An Evaluation of the Anterior–Posterior Laxity Pre- and Post-Cruciate Ligament Resection

Ultrasound properties of liver tissue during heating.

Effect of novel polyethylene insert configurations on bone-implant micromotion and contact stresses in total ankle replacement prostheses: a finite element analysis

Evaluation of the Effect of the Sulcus Angle and Lateral to Medial Facet Ratio of the Patellar Groove on Patella Tracking in Aging Subjects with Stable Knee Joint.

Computational wear of knee implant polyethylene insert surface under continuous dynamic loading and posterior tibial slope variation based on cadaver experiments with comparative verification