Abstract:Helical tube bundles are usually used for steam generators (SGs) and intermediate heat exchangers (IHXs) of High Temperature Gas-cooled Reactors (HTGRs). The thermal hydraulic performance of SGs/IHXs is dominated by the cross flow convection over tube bundles in the primary side. Though cross flow over tube bundles were widely investigated as a basic flow pattern, few of them focused on tube bundles with 1.4-1.6 < S/D < 2-2.2 ( S , tube pitch, D , tube diameter). However, the designs of HTGR SGs or IHXs prefer smaller tube pitches due to the relatively low heat transfer coefficient. In present investigation, velocity distribution, surface pressure distribution and drag/lift force of cross flow over tube bundle with S/D = 1.875 are measured and investigated thoroughly in a wind tunnel. The velocity fields are measured using time resolved PIV and split hot film methods. The surface pressure distribution is measured using dynamic pressure transducers. The drag and lift forces are measured using high frequency wind tunnel balance. Due to the friction drag introduced by the bounded wall, the time averaged velocity in the flow passage next to the bounded wall is smaller than those in the middle flow passages. The surface pres-sure distributions between the impinging point and the separation point on tubes are characterized by the acceleration effects when fluid flowing into the region between neighboring tubes in the same row. The increasingly significant pressure recovery after separation results in the decreasing tendency of flow resistance coefficient with Reynolds number (Re) increment. A main frequency corresponding to Sr = 0.114 (Sr, Strouhal number) is observed in both surface pressure and velocity spectrums, indicating that the vortex shedding induces the turbulent wake swinging. The turbulent wakes after tubes in the same row swing with no phase lag, while turbulent wakes of tubes in neighboring rows swing with a phase lag around 0.33 periods. By using an improved phase average method, phase averaged turbulent statistics and instantaneous coherent structures are obtained. The main flow region swings with vortex shedding. The region with larger (u'u') ( u ' , fluctuating component of stream wise velocity) mainly locates at the shear layer, swinging with the vortex shedding. The region with larger (v'v'), ( v ' , fluctuating component of transverse velocity) mainly locates in front of the tubes, where transverse flow sweeps the upwind side of the tubes. (c) 2022 Elsevier Ltd. All rights reserved.

An Measurement Investigation of the Crossflow Characteristics Through the Liner Holes in a Model Gas Turbine Combustor

Simultaneous Measurements of Velocity and Concentration Fields in an Inclined Jet in Crossflow

Experimental and Numerical Investigation of the Non-Reacting Flow in a High-Fidelity Heavy-Duty Gas Turbine DLN Combustor

Numerical Simulation of Effects of Venturi Tube Throat Diameter on Flow Field of Combustor

Experimental study on discharge coefficient of a cylindrical hole with gas jets in liquid crossflow

Fully Coupled Whole-Annulus Investigation of Combustor–Turbine Interaction with Reacting Flow

Investigation of the Discharge Coefficient for Laidback Fan-Shaped Holes on Turbine Blades Under Internal Crossflow Condition

Experimental and numerical study on heat transfer characteristics of tangential effusion cooling for a combustor liner

Measurements of Heat Transfer and Pressure in a Trailing Edge Cavity of a Turbine Blade

Experimental studies on swirling and recirculating two-phase flow field in a cold model of dual-inlet sudden-expansion combustor

EXPERAMENTAL STUDY ON FLOW FIELD BEHAVIOR CONCERNING THE CROSSED JET FLOWS OF MICRO-SWIRLING PRIMARY AIR AS WELL AS UPPER AND LOWER SECONDARY AIR

Contoured Endwall Flow And Heat Transfer Experiments With Combustor Coolant And Gap Leakage Flows For A Turbine Nozzle Guide Vane

Experimental Investigation on Flow Structures and Mixing Mechanisms of a Gas–solid Burner Jet

Effect of the hole configurations on effusion cooling effectiveness under swirl impact in gas turbine combustor

Experimental Investigation of Turbine Phantom Cooling on Suction Side with Combustor-Turbine Leakage Gap Flow and Endwall Film Cooling

Numerical Investigation on Mechanism of Swirling Flow of the Prefilming Air-Blast Fuel Injector

Experimental and Numerical Investigations of Extended Jet Effects on Multiple-Jet Impingement Heat Transfer Characteristics

Numerical study of effusion cooling of a gas turbine combustor liner

Effect of Different Nozzle Arrangements on Combustion Flow Characteristics in a Swirl Coupling Multiple Direct Injection Combustor

Experimental Investigation and Analysis on the Cross Flow Characteristics over Inline Tube Bundles with S/D=1.875

Numerical investigation of inlet guiding ring effect on combustor flow field with multiple swirler structures