Abstract:Accurate fuel supply is a key factor that influences the performance of high-power natural gas engines. The premixed and single-point natural gas supply system is the most commonly used method to ensure a large fuel supply but one of its shortcomings is the inaccuracy of the fuel supply. A new type of natural gas injection device with fungiform configuration and electronically controlled actuator was developed to achieve high efficiency and stable operation in high-power natural gas engines. Firstly, a computational fluid dynamics (CFD) model of the injection device was created. Based on this model, the key structure parameters that have a significant influence on the outlet flow were confirmed. A particle swarm optimization (PSO) model was developed to identify the optimal outflow structure. Then, a flow function for precise flow supply control was constructed based on a response surface model, according to the flow rates of the device under different control parameters. Finally, a flow-characteristic test bench and a high-power engine prototype were developed to verify the simulation and optimization results. The results indicate that the optimized outflow structure shows low pressure loss and a large flow rate, improving injection efficiency by 10.37% and mass flow by 11.78% under 0.4 Mpa pressure difference. More importantly, the cycle fuel supply could be controlled accurately for each cylinder owing to the developed flow function. Consequently, compared with the original engine using a single-point natural gas supply system, the cylinder performance imbalance was improved by 37.47%.

Flow Field Analysis and Structure Optimization of Steam Injector Based on Fluent and Workbench

A throughflow-based optimization method for multi-stage axial compressor

The CFD Analysis of Cavitation Erosion and Structural Optimization for an Unloading Valve

Numerical Simulation and Optimization of Internal Flow Field in the High Pressure Coal Conveying Pump Based on the Dynamic Mesh

Flow Force Analysis and Structural Optimization of a Large Flow Rate Pressure Compensation Valve

AN OPTIMIZATION STUDY ON CAVITATION FLOW IN A STEAM TRAP VALVE

Optimization Design of Nozzle Structure Inside Boiler Based on Orthogonal Design

Numerical Simulation of Inner Flow Field of a Pintle Injector Variable Thrust Rocket Engine

Optimal Design of Ejector Nozzle Profile with Internal and External Integrated Flow

Non-linear mapping and multi-objective optimization of leading flow structure in plate-fin heat exchanger

Simulation and Analysis of High-pressure Nozzle Geometric Parameters on the Property of Efflux Flow Field

Research on Flow Characteristics of Electronically Controlled Injection Device Developed for High-Power Natural Gas Engines

Valve Plate Structural Optimal Design and Flow Field Analysis for the Aviation Bidirectional Three-Port Piston Pump

Structure Optimization of Natural Gas Engine’s Intake Pipe Based on One-Dimensional and Three-Dimensional Coupled Simulation

Numerical Simulations and Optimization of a Micro Annular Combustor

The Investigation of Geometric Parameters on the Injection Characteristic of the High Pressure Common-Rail Injector

Numerical examination of high-pressure fuel injection in common rail injector based on hydro-mechanical model

Numerical Study and Structural Optimization of Impinging Jet Heat Transfer Performance of Floatation Nozzle

Experimental and numerical investigations on flow field characteristics of pintle injector

Design of high-power synthetic jet actuator and its flowfield investigation

Structural design and flow field analysis of the variable nozzle of turbocharger