Abstract:Abstract The resources of clean water worldwide are very limited, and climate change is already affecting the available supplies. Therefore, developing a low-cost, highly efficient, and recyclable adsorbent to upgrade water quality has become an essential task. Herein, we report the fabrication of activated carbon (AC) adsorbents derived from lignocellulosic wastes. Both physical and chemical activation were investigated to modify the surface texture properties. The results indicated that increasing the activation temperature, whether physically or chemically, increases the specific surface area (S BET ). On the contrary, increasing the amount of the chemical activating agent significantly decreases the S BET values. The S BET of 1771, 2120, and 2490 m 2 g −1 were obtained for water vapor, K 2 CO 3 and KOH, at activation temperatures of 950 °C, 800 °C, and 800 °C, respectively. Methylene blue (MB) and phenol were used as adsorbates for the adsorption experiment. Adsorption of methylene blue dye revealed the ability of the water activated carbon to remove more than 95% of the dye (100 ppm) within 5 min with an adsorption capacity of 148.8 mg g −1 . For phenol adsorption, Several parameters were investigated, including initial concentration (50–250 ppm), pH (2–10), contact time (5–60 min), and temperature (25–45 °C). The highest adsorption capacity of phenol achieved was 158.9 mg g −1 . The kinetics of adsorption of phenol was better described by pseudo-second-order reaction while the isotherm process using Langmuir model. This study presents a roadmap for conversion of lignocellulosic biomass waste into highly efficient porous carbon adsorbents.

Removal of Chlorophenol in Waste Solution by Activated Carbon Produced from Reed Pulp Lignin by Precarbonization

Removal of phenol in the bleaching effluent with activated carbon produced from reed black liquor lignin

Removal of pollutants with activated carbon produced from K2CO3 activation of lignin from reed black liquors

Removal of phenol by lignin-based activated carbon as an efficient adsorbent for adsorption of phenolic wastewater

Removal of nitrobenzene in the effluent by activated carbon from reed black liquor lignin

On the Adsorption Capability of Powder Activated Carbon for Phenol

Adsorption and Desorption of Phenol on Activated Carbon Fibers in A Fixed Bed

The Adsorption of Phenol by Lignite Activated Carbon

SORPTION OF PHENOL ON ACTIVATED CARBON FIBERS IN A FIXED BED AND REGENERATION

Preparation of Activated Carbon with Large Specific Surface Area from Reed Black Liquor

Experimental Study on the Preparation of Lignin-Based Activated Carbon and the Adsorption Performance for Phenol

Phenol removal via activated carbon from co-pyrolysis of waste coal tar pitch and vinasse

Removal of Phenol by Powdered Activated Carbon Adsorption

Spherical Lignin-Derived Activated Carbons for the Adsorption of Phenol from Aqueous Media

Adsorption of phenol on CO2-treated activated carbon

High adsorption capacity of phenol and methylene blue using activated carbon derived from lignocellulosic agriculture wastes

Adsorption of Phenol on Commercial Activated Carbons: Modelling and Interpretation

Adsorption and Treatment of Simulated Coking Waste Water by Activated Carbon Fiber

A Study of the Preparation of Activated Carbon from Corn Stalk Black Liquor Lignin

Characteristics of activated carbon from sludge and peanut shell and its application for phenol adsorption

Systematic studies on the effect of structural modification of orange peel for remediation of phenol contaminated water