Abstract:Accurate prediction of the laminar-turbulent transition with the aerodynamic force and heat in hypersonic boundary flows is essential for the design of a hypersonic vehicle. However, subject to the complex boundary layer mechanism of the angle of attack (AOA) effects, the numerical prediction with high accuracy of hypersonic transitional flows over a cone at a small AOA is still a challenging job in current computational fluid dynamic (CFD) modeling. In this paper, our objective is to improve the prediction accuracy of the traditional turbulent model in the boundary layer flow problems. We employ a gas-kinetic scheme (GKS) strongly coupled with the turbulent kinetic energy equation in the shear stress transport (SST) turbulence model. Langtry-Menter's two-equation transition model is also implemented under the GKS framework. The turbulent relaxation time obtained from the turbulence model is also implemented into the kinetic equation of the BGK model as an enhanced particle collision time related to turbulent fluctuation. We further validate this method for several classic cases of the hypersonic transitional flows over cones with various free-stream conditions at zero AOA. We also compare the numerical solutions by the current GKS coupled with the turbulent kinetic energy equation and traditional Reynolds-Averaged Navier–Stokes (RANS) method. The numerical results confirm the consistency of the transition onset locations predicted by the proposed method with the experiments. The new coupled method also significantly improves numerical accuracy. The heat flux is also in good agreement with the experimental data. The hypersonic flows past a sharp cone are also computed at various small angles of attack ranging from 2° to 4°, where the numerical results agree with the existing experimental data. Using our results we also analyze the impact of AOA on a sharp cone.

Supersonic Flow Air Data Acquisition Algorithm Using Total Pressure Sensors

A New Data Assimilation Method of Recovering Turbulent Mean Flow Field at High Reynolds Numbers

Data-Driven Method for Flow Sensing of Aerodynamic Parameters Using Distributed Pressure Measurements

Computation of Hypersonic Transitional Flows Over Cones Using Gas-Kinetic Scheme Coupled with the Turbulence Model

Aircraft aerodynamic parameter detection using micro hot-film flow sensor array and BP neural network identification

Research on Embedded Atmospheric Measurement Method Based on Three-point Method

Establishment of super sonic inlet flow pattern monitoring system: A workflow

Adaptive sampling of pressure distribution features for the airfoil statistical analysis

High-fidelity surface flow data-driven aerodynamic solution strategy for non-smooth configurations: Study of compressor cascade with micro riblet surface

Predictor–Corrector Method for Scramjet Inlet Air Mass Flow Rate Measurement

A data-driven approach to guide supersonic impinging jet control

Pressure Distribution Feature-Oriented Sampling for Statistical Analysis of Supercritical Airfoil Aerodynamics

Data-Driven Estimation of the Unsteady Flowfield Near an Actuated Airfoil

Information-Based Sensor Placement for Data-Driven Estimation of Unsteady Flows

Development on Unsteady Aerodynamic Modeling Technology at High Angles of Attack

Data Assimilation of Ideally Expanded Supersonic Jet Using RANS Simulation for High-Resolution PIV Data

Neural Network-Based Airflow Vector Sensor Using Multiple MEMS Differential Pressure Sensors

A new data assimilation method of recovering turbulent flow field at high-Reynolds numbers for turbulence machine learning

Numerical Simulations of Morphology, Flow Structures and Forces for a Sonic Jet Exhausting in Supersonic Crossflow

Sensitivity Analysis for Knowledge Discovery in Scramjet Intake Design Optimization Using Deep-Learning Flowfield Prediction

Investigation of suddenly expanded flows at subsonic Mach numbers using an artificial neural networks approach