Promoting photocatalytic CO2 reduction to CH4 via a combined strategy of defects and tunable hydroxyl radicals
Dou Zhang,Ying-Jie Sun,Xiao Tian,Xue-Ting Liu,Xiao-Jing Wang,Jun Zhao,Yu-Pei Li,Fa-Tang Li,Ying-jie Sun,Xiao-jing Wang,Yu-pei Li,Fa-tang Li
DOI: https://doi.org/10.1016/j.jcis.2021.08.163
IF: 9.9
2022-01-01
Journal of Colloid and Interface Science
Abstract:A well-designed photocatalyst with excellent activity and selectivity is crucial for photocatalytic CO<sub>2</sub> conversion and utilization. TiO<sub>2</sub> is one of the most promising photocatalysts. However, its excessive surface oxidation potential and insufficient surface active sites inhibit its activity and photocatalytic CO<sub>2</sub> reduction selectivity. In this work, highly dispersed Bi<sub>2</sub>Ti<sub>2</sub>O<sub>7</sub> was introduced into defective TiO<sub>2</sub> to adjust its oxidation potential and the generation of radicals, further inhibiting reverse reactions during the photocatalytic conversion of CO<sub>2</sub>. Moreover, an in situ topochemical reaction etching route was designed, which achieved defective surfaces, a contacted heterophase interface, and an efficient electron transfer path. The optimized heterophase photocatalyst exhibited 93.9% CH<sub>4</sub> selectivity at a photocatalytic rate of 6.8 μmol·g<sup>-1</sup>·h<sup>-1</sup>, which was 7.9 times higher than that of P25. This work proposes a feasible approach to fabricating photocatalysts with well-designed band structures, highly dispersed heterophase interfaces, and sufficient surface active sites to effectively modulate the selectivity and activity of CO<sub>2</sub> photoreduction by manipulating the reaction pathways.
chemistry, physical