Abstract:CO2 sequestration technology is crucial for carbon capture and storage. Methane hydrate formation and dissociation, CO2 and water injection processes are experimentally simulated to evaluate the entire technological process. Generally, two common methods of CO2 storage are geological storage and ocean storage. CO2 storage in marine sediments is a persistent and safe method and most sites are conducive for CO2 hydrate formation. CO2 storage in form of hydrate are theoretically both stable and permanent. For the selection of CO2 storage sites, depleted natural gas hydrate deposit is favourable and beneficial. Firstly, the phase equilibrium pressure of CO2 hydrate is usually lower than that of methane hydrate,hence depleted natural gas hydrate deposits can meet the requirement of CO2 hydrate stability. Secondly, residual marine clathrate structures in depleted natural gas hydrate deposits can improve CO2 hydrate formation which enhances the storage efficiency. Thirdly, the scale of gas hydrate commercial-use reserves is large enough to satisfy CO2 storage capacity requirements. Fourthly, CO2 hydrate formation in depleted natural gas hydrate deposit after methane recovery is beneficial to preserve the mechanical behaviour of marine sediments. That increases the safety of hydrate exploitation and CO2 storage. Currently, most investigations about CO2 storage in marine sediment are CO2–methane exchange, which is quite different from this study. The CO2–methane exchange researches are aimed to enhance gas hydrate dissociation while store CO2. CO2–methane exchange is beneficial for methane recovery and CO2 storage. However, this method is still immature because of its slow replacement process. CO2 sequestration in depleted methane hydrate reservoirs can also achieve the goals but very few studies refer to this topic nowadays. Previous investigations have been done in our lab. The purpose of those studies is improving the stability, efficiency and safety of CO2 storage after methane recovery. In those studies, CO2 injection into the glass beads after methane recovery in the laboratory was conducted to simulate the CO2 storage characteristics in depleted marine methane hydrate deposits. Methane hydrate formation and dissociation, CO2 and water injection processes and liquid water saturation and distribution were monitored by magnetic resonance imaging. The effects of different parameters on CO2 hydrate formation are analysed to evaluate hydrate-based CO2 sequestration technologies. In methane hydrate formation initial water saturation in glass beads determines methane hydrate saturation. In methane hydrate dissociation process, depressurization amplitude is the dominated factor influencing methane hydrate dissociation rate. In CO2 injection process, pressure is the key factor influencing the CO2 hydrate formation. CO2 injection rate is negatively correlated with CO2 saturation and CO2 conversion rate. A higher CO2 flow rate results in lower CO2 hydrate saturation and CO2 conversion rate. However, the final CO2 hydrate formation is still determined by initial water saturation in glass beads, which is similar with methane hydrate formation. Water injection was intended to enhance CO2 hydrate formation but has no effects on CO2 water injection. The

Enhanced Gas Production and CO2 Storage in Hydrate-Bearing Sediments Via Pre-Depressurization and Rapid CO2 Injection

Experimental Studies on Gas Hydrate-Based CO2 Storage: State-of-the-Art and Future Research Directions

An approach to the high efficient exploitation of nature gas hydrate and carbon sequestration via injecting CO2/H2 gas mixture with varying composition

Spatial Evolution of CO2 Storage in Depleted Natural Gas Hydrate Reservoirs and Its Synergistic Efficiency Analysis

A new approach to efficient and safe gas production from unsealed marine hydrate deposits

Study of CO2 injection to enhance gas hydrate production in multilateral wells

Numerical Investigation of CO2 Storage Capacity Via Hydrate in Deep-Sea Sediments

CO2sequestration in Depleted Methane Hydrate Deposits with Excess Water

Methane Recovery and Carbon Dioxide Storage from Gas Hydrates in Fine Marine Sediments by Using CH4/CO2 Replacement

of CO 2 sequestration in depleted methane hydrate reservoirs

Promoting CH4/CO2 Replacement from Hydrate with Warm Brine Injection for Synergistic Energy Harvest and Carbon Sequestration

Self-adaptive Gas Flow and Phase Change Behaviors During Hydrate Exploitation by Alternate Injection of N2 and CO2

Effectiveness of CO2-N2 Injection for Synergistic CH4 Recovery and CO2 Sequestration at Marine Gas Hydrates Condition

CO2 Sequestration in Depleted Methane Hydrate Sandy Reservoirs

An Experimental Investigation on the Kinetics of Integrated Methane Recovery and CO2 Sequestration by Injection of Flue Gas into Permafrost Methane Hydrate Reservoirs

CH4 hydrate production coupled with CO2 sequestration and hydrate restoration employing depressurization assisted by CO2-N2 injection at marine conditions

Enhancing Gas Production and CO2 Sequestration from Marine Hydrate Reservoirs Through Optimized CO2 Hydrate Cap

Advances in research and developments on natural gas hydrate extraction with gas exchange

Gas production from unsealed hydrate-bearing sediments after reservoir reformation in a large-scale simulator

Numerical simulation of gas production from permafrost hydrate deposits enhanced with CO2/N2 injection

Enhanced CH4 Recovery and CO2 Storage Via Thermal Stimulation in the CH4/CO2 Replacement of Methane Hydrate