Effects of Catalytic Mineral Matter on CO/CO[sub 2] Temperature and Burning Time for Char Combustion

J P Longwell,A F Sarofim,Chun-Hyuk Lee,Changhe Chen
DOI: https://doi.org/10.2172/7053918
1992-01-01
Abstract:Results (solid-1600K, open-2000K surface temperature) from Fig.3 show that oxygen and nitrogen distributions are almost same although there is a little particle shrinkage (r[sub o]=0.009cm). C0[sub 2]/CO ratio drop significantly as the temperature increases, which is opposite to experimental results reported earlier. The cause of this behavior is mainly due to the lack of gas phase CO oxidation. Therefore, C0[sub 2]/CO ratio are directly related to C0[sub 2] and CO production of the heterogeneous reaction, which generates less C0[sub 2] as the temperature goes up. To get CO oxidation in the gas phase boundary layer, we may need to incorporate more elementary reactions. But the computation time currently used for one ignition-extinction calculation is about 2 Cray CPU hours, which is very long, and will be longer if we incorporate full reaction kinetics. Actually we don't need temperature and mass fraction distribution through the whole time span, there's a need to develop a gas phase model which calculates distributions for only one surface temperature. A model incorporating full reaction set is under development using the time dependent results of SCOM as an initial guess.
What problem does this paper attempt to address?