Abstract:Sulfur dioxide (SO2) is a toxic gas at low parts-per-million (ppm) concentrations, with a permissible exposure limit (PEL) of 2 ppm. Its detection is mandatory, particularly in the fields of occupational health and safety, and environmental pollution. In this work, ppm concentration detection of sulfur dioxide was performed in six room temperature ionic liquids (RTILs), as well as on two different electrode materials - platinum and gold - and with two different electrode geometries, i.e. macro thin-film electrodes (TFEs) and microarray thin-film electrodes (MATFEs). Calibration curves were established for 10-200 ppm SO2 using cyclic voltammetry to determine the optimum combination of RTIL, electrode surface and geometry for the sensing. The RTIL 1-butyl-1-methylpyrrolidinium bis(trifluoromethylsulfonium)imide ([C4mpyrr][NTf2]) with a platinum thin-film electrode was found to give the best response due to the relatively low viscosity of the RTIL combined with the high sensitivity and a clean blank response. On MATFEs, deposited sulfur particles - confirmed using scanning electron microscopy (SEM) coupled to an energy dispersive spectrometer - were found to passivate and block some of the microholes, leading to unstable long-term chronoamperometric responses. To the best of our knowledge, this is the first observation of sulfur deposition from SO2 reduction in aprotic ionic liquids. Consecutive additions of 2 ppm SO2 were studied in [C4mpyrr][NTf2] on a TFE using long-term chronoamperometry, showing excellent reproducibility upon successive additions. This demonstrates that small volumes of RTILs can be combined with miniaturized, low-cost TFEs and applied for the reliable and continuous monitoring of sulfur dioxide gas at concentrations lower than the permissible exposure limit of 2 ppm.

Electrochemical Studies of Sulfur Dioxide Absorption and Desorption in Ionic Liquids

Electrochemical Properties of a 2D-Molybdenum Disulfide–modified Electrode and Its Application in SO2 Detection

Experimental Study on Volatile Sulfur Compound Inhibition Using a Single-Chamber Membrane-Free Microbial Electrolysis Cell

Fabrication and application of a 3D-rGO electrochemical sensor for SO 2 detection in ionic liquids

An Electrochemical Sensor for Determination of Sulfite (SO32-) in Water Based on Molybdenum Disulfide Flakes/Nafion Modified Electrode

Detection of sulfur dioxide at low parts-per-million concentrations using low-cost planar electrodes with ionic liquid electrolytes

Absorption Of Sulfur Dioxide By Tetraglyme-Sodium Salt Ionic Liquid

An Ionic Liquid-Mediated Electrochemiluminescent Sensor for the Detection of Sulfur Dioxide at the Ppb Level

Ultrasensitive Ion Liquid-Cnt Vdw Heterostructure Interface Via Anion-Cation Pair Switch for SO2 Detection

Ab Initio Study of SOF2 and SO2F2 Adsorption on Co-MoS2

Reversible SO2 Removal from Simulated Flue Gas by Ion Exchange Membranes Using the Humidity-Swing

MoS2-doped Spherical SnO2 for SO2 Sensing under UV Light at Room Temperature

Monoethanolamine-enabled Electrochemical Detection of H2S in a Hydroxyl-Functionalized Ionic Liquid

Investigation of Highly Efficient and Reversible Absorption of SO2 Using Ternary Functional Deep Eutectic Solvents

Reversible capture of SO2 through functionalized ionic liquids

The study of PVP/Pd/IrO2 modified sensor for amperometric determination of sulfur dioxide

Theoretical study of excited state dynamics of a ratiometric fluorescent probe for detection of SO2 derivatives

Development of Sulphur Sensor Using MgS+TiS2 Solid Electrolyte

Double Bond Carboxylate Ionic Liquids for Reversible SO2 Capture

Retarding SO2 poisoning effect and expanding detection range via changing the sulfate content in Mn/Ce composite oxides sensing electrode of mixed-potential type SO2 sensor

Efficient Absorption of Low Partial Pressure SO<sub>2</sub> by 1-Ethyl-3-methylimidazolium Chloride Plus N-Formylmorpholine Deep Eutectic Solvents