Abstract:The adsorption structure and orientation of acetonitrile on TiO2(110) have been investigated by temperature-programmed desorption (TPD) and high resolution broadband sum frequency generation vibrational spectroscopy (HR-BB-SFGVS) in combination with ab initio molecular dynamics (AIMD) simulation. Sub-monolayer, monolayer, and multilayer states of acetonitrile on TiO2(110) have been unambiguously distinguished in the TPD spectra. The in situ HR-BB-SFG vibrational spectra of acetonitrile on TiO2(110) at 100 K not only show the symmetric stretching mode of the methyl group and the nitrile group, similar to those of vapor acetonitrile on oxide surfaces, but also present an intense antisymmetric stretching mode of the methyl group as well as the sum resonance mode between symmetric C-C stretching and symmetric CH3 deformation. Besides, two adsorption forms for acetonitrile on TiO2(110), including interactions with five-coordinated titanium (Tice) and bridge bonded oxygen (Obr) vacancies, have also been resolved and identified in our SFG vibrational spectra. By the combination of SFG polarization analyses and AIMD simulations, we further found that the tilt angle of CH3CN on TiO2(110) decreases as the coverage increases from submonolayer to monolayer. Considering the down shifts of desorption temperature, vibrational frequency, and adsorption energy for acetonitrile on TiO2(110) at higher coverage, we propose that the intermolecular repulsion plays a major role in the coverage-dependent adsorption configuration. Our results not only provide a detailed insight into the adsorption states of acetonitrile on TiO2(110) at a low temperature but also demonstrates the capabilities of high-resolution SFG-VS for investigating the complicated structure and orientation of adsorbates on single-crystal metal oxides.

Coverage Dependence of the Structure of Tetracene on Ag(110)

Electronic properties and adsorption structures of tetracene on the Ag(110) surface

Monolayer Structure Of Tetracene On Cu (100) Surface: Parallel Geometry

Exploring the Adsorption Mechanism of Tetracene on Ag(110) by STM and Dispersion-Corrected DFT

Molecular assembly of tetracene on the (2×1)O reconstructed Cu(110) surface

Study on the Interaction Between Tetracene and Cu(110) Surface.

The Structure and Electronic State of the Ordered Thin Film of Perylene and Tetracene on Ag(110) Surface

Electronic and structural investigation of tetracene adsorbed on Ru(101̄0) surface

Electronic and Structural Investigation of Tetracene Adsorbed on Ru(1010) Surface

Adsorption structures of tetracene on the Ru(1 0 over(1, ̄) 0) surface

Electronic and structural investigation of tetracene adsorbed on Ru(10(1)over-bar0) surface

Density Functional Theory Calculations of Tetracene on Low Index Surfaces of Copper Crystal

Adsorption Geometry of Tetracene on SiO2/Si (111) Substrate with the Balance of Molecule–substrate and Intermolecular Interaction

Adsorption geometry and electronic properties of flat-lying monolayers of tetracene on the Ag(111) surface

Study of the Initial Adsorption State of Tetracene On

The Chemisorption of Tetracene on Si(100)-2x1 Surface

Coverage Dependent Structural Change in Tetrahydrothiophene Adsorbed on Ge(100) Surface

Adsorption Structure and Coverage-Dependent Orientation Analysis of Sub-Monolayer Acetonitrile on TiO2(110)

Interfacial Electronic States of Tetracene Deposited on Si(111).

Temperature and coverage driven condensation of pentacene on the Si(111)-–Ag surface

Effect of Charge Transfer on the Geometric Structure of a C70monolayer on the Surface of Ag(111)