Abstract:The 3D architecture of Co(II) oxide (CoO) having oxygen defects has been recognized as a highly functional characteristic towards efficient electrocatalysis of water. Herein, different surface structures of CoO in the form of chemically deposited films were fabricated via AACVD technique, directly over the transparent fluorine-doped tin oxide (FTO) electrodes just by varying the deposition times. The as-prepared films were characterized by scanning electron microscopy (SEM), energy-dispersive X-ray (EDX), X-ray diffraction (XRD), and X-ray photoelectron spectroscopy (XPS). As the deposition time is varied, the surface structure of the CoO changes from nanoparticles that are formed just in 15 min to nanobuds at 30-min deposition, and finally to a homogeneously distributed dense population of nanoflowers in 45 min. The evolution of these structures was also accompanied by a preferential exposure of (111) facets and an increasing number of oxygen defects which resulted in an enhancement of electrocatalytic activity towards water oxidation. The CoO nanoflowers (CoO-NFs) with highest number of these active oxygen vacancies showed the best performance with an overpotential of 325 mV vs RHE for a current density of 10 mA/cm2 while having a Taefl slope of 98 mV/dec, a mass activity of 35.2 A/g, and the electrochemically active surface area (ECSA) of 1069 μF. However, more importantly, the current density for CoO-NF jumped sharply to the values above 200 mA/cm2 with potential less than 1.8 V vs RHE, thereby meeting the commercialization standards while still providing high stabilities of oxygen generation, current densities, and repeated cycling. Such a performance can be considered remarkable for a material fabricated via a rapid and facile synthetic route and is directly deposited on a low cost and relatively less conductive FTO substrate which can be attributed to the synergistic effect of the larger specific surface area of 3D structure and the high distribution of oxygen defects.

Aqueous Chemical Growth of &Lt;i>α</i>-Fe<sub>2</sub>o<sub>3</sub>–<i>α</i>-cr<sub>2</sub>o<sub>3</sub> Nanocomposite Thin Films

Aqueous chemical growth of alpha-Fe2O3-alpha-Cr2O3 nanocomposite thin films.

Aqueous chemical growth of advanced nanostructured metal oxides thin films

3-D Nanoengineering of Metal Oxides and Oxyhydroxides by Aqueous Chemical Growth

Growth and process conditions of aligned and patternable films of iron(III) oxide nanowires by thermal oxidation of iron.

Aqueous Purpose-Built Nanostructured Metal Oxide Thin Films

Nanostructured hematite photoelectrochemical electrodes prepared by the low temperature thermal oxidation of iron

Controlled Aqueous Chemical Growth of Oriented Three-Dimensional Crystalline Nanorod Arrays: Application to Iron(III) Oxides

Facile Solution Synthesis of Α-Fef3·3h2o Nanowires and Their Conversion to Α-Fe2o3 Nanowires for Photoelectrochemical Application

Low-Temperature Atomic Layer Deposition of Crystalline and Photoactive Ultrathin Hematite Films for Solar Water Splitting

A nanostructured hematite film prepared by a facile "top down" method for application in photoelectrochemistry.

Single-crystalline Α-Fe2o3 Nanostructures: Controlled Synthesis and High-Index Plane-Enhanced Photodegradation by Visible Light

3D Highly Oriented Nanoparticulate and Microparticulate Array of Metal Oxide Materials

Facile Synthesis of Highly Photoactive Α-Fe₂o₃-based Films for Water Oxidation.

Phase-transition-induced One-Dimensional Amorphous Α-Fe2o3/β-feooh Homojunction for Efficient Photocatalytic Water Oxidation

Surface Modification of α-Fe<sub>2</sub>O<sub>3</sub> Nanorod Array Photoanodes for Improved Light-Induced Water Splitting

Unveiling Enhanced PEC Water Oxidation: Morphology Tuning and Interfacial Phase Change in α-Fe 2 O 3 @K-OMS-2 Branched Core-Shell Nanoarrays

Facile Solvothermal Method for Fabricating Arrays of Vertically Oriented α-Fe<sub>2</sub>O<sub>3</sub> Nanowires and Their Application in Photoelectrochemical Water Oxidation

Modulated Structure Assisted Growth and Properties of Fe3o4 Nanoneedle Films Using A Thermal Oxidation Process in the Air

Facile Solvothermal Method for Fabricating Arrays of Vertically Oriented Α-Fe2o3 Nanowires and Their Application in Photoelectrochemical Water Oxidation

Hierarchical Growth of CoO Nanoflower Thin Films Influencing the Electrocatalytic Oxygen Evolution Reaction

Aqueous Chemical Growth of &Lt;i&gt;α&lt;/i&gt;-Fe&lt;sub&gt;2&lt;/sub&gt;o&lt;sub&gt;3&lt;/sub&gt;–&lt;i&gt;α&lt;/i&gt;-cr&lt;sub&gt;2&lt;/sub&gt;o&lt;sub&gt;3&lt;/sub&gt; Nanocomposite Thin Films