Abstract:Microscale cell culture devices with two or more cell types, such as the micro cell culture analog (microCCA), are promising devices to predict mammalian response to toxic drug and chemical exposure. A polydimethylsiloxane (PDMS) version of such microfluidic devices has been challenging to construct due to the difficulty of patterning multi cell types directly into designated individual cell culture chambers in an oxygen plasma bonded PDMS device. Approaches with micro-valves for flow control are complex, expensive and inconvenient to use. In this study, an alternative approach using polyethylene glycol diacrylate (PEG-DA) for spatially controlled multi-cell type patterning inside a bonded microCCA device is described. We constructed a three-cell type PDMS microCCA following a human physiologically based pharmacokinetic (PBPK) modeling, and applied continuous cell culture medium recirculation within the device as a blood surrogate. A fluorescence microscope based direct pattern writing method was used to form cell/hydrogel microstructures with higher cell viability than the traditional UV lamp based method. The positive effect of mixed molecular weight PDG-DA on hydrogel-encapsulated cell membrane integrity was also studied. This prototype PDMS microCCA device was then tested with Triton X-100 as a model toxicant. The combination of hydrogel photo-patterning and the microfluidic cell culture platform enables the fabrication of simple and low cost multi-cell type biosensors for drug development, toxicity study and clinical diagnosis.

Development of PDMS-based Microfluidic Device for Cell-based Assays

PDMS-based microfluidic device with multi-height structures fabricated by single-step photolithography using printed circuit board as masters.

Rapid Prototyping of Soft Lithography Masters for Microfluidic Devices Using Dry Film Photoresist in a Non-Cleanroom Setting

A Simple Method For Fabrication Of Microstructures Using A Pdms Stamp

Inexpensive and rapid fabrication of PDMS microfluidic devices for biological testing applications using low cost commercially available 3D printers

PDMS-Based Microfluidic Devices for Cell Culture

Development of disposable PDMS micro cell culture analog devices with photopolymerizable hydrogel encapsulating living cells

Novel polydimethylsiloxane (PDMS) based microchannel fabrication method for lab-on-a-chip application

Rapid Customization of 3d Integrated Microfluidic Chips Via Modular Structure-Based Design

Fabrication of Microfluidic Systems in Poly(dimethylsiloxane)

A simple and cost-effective method for fabrication of integrated electronic-microfluidic devices using a laser-patterned PDMS layer

Direct Optical Micropatterning of Poly(dimethylsiloxane) for Microfluidic Devices

Route to one-step microstructure mold fabrication for PDMS microfluidic chip

Fabrication and Demonstration of a 3D-printing/PDMS Integrated Microfluidic Device

A simple method for fabricating multi-layer PDMS structures for 3D microfluidic chips

PDMS-based microfluidic devices using commoditized PCBs as masters with no specialized equipment required

Observation Interface of PDMS Membrane in a Microfluidic Chip Based on One-Step Molding

PDMS Molding Technology Using in Extract Typical Characteristic in Microfluidic-Chip

Microfluidic Device with Compound Structure

Design and fabrication of a PDMS microchip based immunoassay

Fabrication of Microfluidic Manifold by Precision Extrusion Deposition and Replica Molding for Cell-Laden Device