Abstract:Abstract A big challenge in tight conventional and unconventional rock systems is the lack of representative reservoir deliverability models for movement of water, oil and gas through micro-pore and nano-pore networks. Relative permeability is a key input in modelling these rocks; but due to limitations in core analysis techniques, permeability has become a knob or tuning parameter in reservoir simulation. Current relative permeability measurements on conventional core samples rely on density contrast between oil/water or gas/water on CT (Computed Tomography) scans and recording of effluent volumes to determine relative fluid saturations during the core flooding process. However, tight rocks are characterized by low porosities (< 10 %) and ultra-low permeabilities (< 1 micro-Darcy), that make effective and relative permeability measurements very difficult, time-consuming, and prone to high errors associated with low pore volumes and flow rates. Nuclear Magnetic Resonance (NMR) measurements have been used extensively in the industry to measure fluid porosities, pore size characterization, wettability evaluation, etc. Core NMR scans can provide accurate quantification of pore fluids (oil, gas, water) even in very small quantities, using T2, T1T2 and D-T2 activation sequences. We have developed a novel process to perform experiments that measure effective and relative permeability values on both conventional and tight reservoirs at reservoir conditions while accurately monitoring fluid saturations and fluid fronts in a 12 MHz 3D gradient NMR spectrometer. The experimental process starts by acquiring Micro-CT scans of the cylindrical rock plugs to screen the samples for artifacts or microcracks that may affect permeability measurements. Once the samples are chosen, NMR T2 and T1T2 scans are performed to establish residual fluid saturations in the as-received state. If a liquid effective permeability test is required, the samples are then saturated with the given liquid through a combination of humidification, vacuum-assisted spontaneous imbibition, and saturation under pressure and temperature. After saturation, NMR scans are obtained to verify the volumes of the liquids and determine if the samples have achieved complete saturation. The sample is then loaded into a special core-flooding vessel that is invisible to the NMR spectrometer to minimize interference with the NMR signals from the fluids in the sample. The sample is brought up to reservoir stress and temperature, and the main flowing fluid is injected from one side of the sample while controlling the pressures on the other side of the sample with a back pressure regulator. The saturation front of the injected fluid is continuously monitored using 2D and 3D gradient NMR scans and the volumes of different fluids in the sample are measured using NMR T2 and T1T2 scans. The use of a 12 MHz NMR spectrometer provides very high SNR (signal-to-noise ratio); and clear distinction of water and hydrocarbon signals in the core plug during the entire process. The scanning times are also reduced by orders of magnitude, thereby allowing for more scans to properly capture the saturation front and changes in saturation. Simultaneously, the fluid flowrates and pressures are recorded in order to compute permeability values. The setup is rated to 10,000 psi confining pressures, 9000 psi of pore pressure and a working temperature of up to 100 C. Flowrates as low as 0.00001 cc/min can be recorded. These tests have been done with brine, dead and live crudes, and hydrocarbon gases. The measured relative permeability values have been used successfully in both simulation and production modelling studies in various reservoirs worldwide.

Water Flooding Studied by Measuring NMR Two-Dimensional Distribution Function

The Observation of Residual Oil Evolution During Waterflooding Using NMR D–T 2 Maps

Experimental study on water flooding mechanism in low permeability oil reservoirs based on nuclear magnetic resonance technology

Nuclear magnetic resonance experiments on the time-varying law of oil viscosity and wettability in high-multiple waterflooding sandstone cores

Two-Dimensional NMR Spectroscopy for Observing Rock Wettability

Laboratory NMR Study to Quantify the Water Saturation of Partially Saturated Porous Rocks

Quantitative Investigation of Water Sensitivity and Water Locking Damages on a Low-Permeability Reservoir Using the Core Flooding Experiment and NMR Test

Characterization of Residual Oil Distribution in Sandstone by NMR: A Microscopic View on Oil Recovery by Miscible CO2 Flooding

Experimental study on CO2/Water flooding mechanism and oil recovery in ultralow - Permeability sandstone with online LF-NMR

Core Effective and Relative Permeability Measurements for Conventional and Unconventional Reservoirs by Saturation Monitoring in High Frequency 3d Gradient NMR

Effect of pore structure and injection pressure on waterflooding in tight oil sandstone cores using NMR technique and pore network simulation

Probing Dynamics and Wettability of Water and Oil in Conventional and Unconventional Sandstone Rock Cores by Field-Cycling NMR Relaxometry

A New Waterflood Initialization Protocol With Wettability Alteration for Pore-Scale Multiphase Flow Experiments

Nuclear magnetic resonance study on wettability of shale oil reservoir

Investigation of the Combination Mechanism of Spontaneous Imbibition and Water Flooding in Tight Oil Reservoirs Based on Nuclear Magnetic Resonance

Quantitative analysis on distribution of microcosmic residual oil in reservoirs by frozen phase and nuclear magnetic resonance (NMR) technology

The Saturation Calculation of NMR Logging Based on Constructing Water Spectrum Function

Characterizing pore-level oil mobilization processes in unconventional reservoirs assisted by state-of-the-art nuclear magnetic resonance technique

Simultaneous Measurements of Oil- and Water-Content in Crude Oil-Polluted Sands with NMR-Deconvolution Analysis

Oil distribution and dynamic characteristics of tight oil sandstone cores during spontaneous imbibition-plus-waterflooding and waterflooding-only using nuclear magnetic resonance

Monitoring oil displacement and CO2 trapping in low-permeability media using NMR: A comparison of miscible and immiscible flooding