Crack Tip Stress Fields for Anisotropic Materials with Cubic Symmetry

D. E. Lempidaki,Noel P. O’Dowd,Esteban P. Busso

2013-01-01

Abstract:Fracture mechanics of linear elastic materials is generally based on the K field which has been derived for isotropic materials. Many applications require the use of advanced materials, which are often anisotropic and thus the isotropic elastic K-field is not applicable. In this work, a sharp crack lying in a homogenous, anisotropic material with cubic symmetry is studied and crack tip stress fields are presented. It is shown that the crack tip fields depend on material properties through the anisotropy factor, ρ. The stress fields are applicable for both plane stress and plane strain conditions, though the definition of ρ is different in each case. The theoretical K field obtained has been compared to results from finite element studies and excellent agreement has been obtained. Introduction The majority of solutions for crack tip fields address the problem of a crack within an isotropic material and are based on the isotropic K-field [1]. In this work, crack tip fields for materials with cubic symmetry only are examined. The motivation for the work arises from the increasing use of single crystal nickel alloys (which have elastic cubic symmetry) in gas turbine blades. In [2], Sih et al. investigated the stress fields in the vicinity of a sharp crack lying within an anisotropic solid. Following the approach presented in [3] the elastic crack tip fields were obtained and it was shown that the square root crack tip singularity is present in the anisotropic case. More recently, stress fields for interface cracks in linear elastic anisotropic bimaterials have been examined in [4], [5]. Fourier transforms were used in [4], [5] to obtain the full crack tip fields of a finite crack lying along the interface between anisotropic elastic media. More recently, crack tip fields around kinked cracks in anisotropic elastic solids were obtained [6], [7]. In [6], the Stroh formalism is used to derive crack tip fields, in anisotropic elastic solids, including elastic T-stresses and other coefficients of the higher-order terms. Numerical results for various kink angles and mode mixities, were presented. The problem of an inclined crack in an orthotropic medium was studied in [8] and fully analytical solutions for crack tip fields in orthotropic materials have been obtained using complex potentials. One of the drawbacks of these earlier works is that the precise form of the crack tip stress distributions has not been provided, so analytical studies of cracks in anisotropic