Abstract:The authors propose a general design model based on low‐power embedded circuitry for a multi‐function metasurface element and give the corresponding numerical analysis. The authors present a reconfigurable method based on the general design model and prove that the method achieves independent regulation of amplitude and phase for the reflected electromagnetic wave. Through analysis of the sensitive area at the bottom of the embedded circuit, a gradient descent algorithm is proposed to find the optimised phase points according to device sensitivity of the application scenario and suitable strategy. Implementation of reconfigurable metasurfaces demands a complex structure. The design methodology for metasurface elements based on PIN diodes requires targeted optimisation tailored to the varying application environments and cannot be directly transplanted from one methodological approach to another. In addition, inclusion of varactors often imposes undesirable high‐power consumption with complex analog drive circuitry. Furthermore, the design method for the reconfigurable metasurface element has not been simplified and unified, hindering the rapid deployment of metasurface applications. The authors propose a general design model based on low‐power embedded circuitry for a multi‐function metasurface element and give the corresponding numerical analysis. The authors present a reconfigurable method based on the general design model and prove that the method achieves independent regulation of amplitude and phase for the reflected electromagnetic wave. Through analysis of the sensitive area at the bottom of the embedded circuit, a gradient descent algorithm is proposed to find the optimised phase points according to device sensitivity of the application scenario and suitable strategy. Finally, the authors demonstrate that the designed metasurface element possesses phase control capability and decent phase consistency obtained via far‐field scanning experiments. The proposed element design method will provide a theoretical reference for the integrated design of metasurface.

Design of Ultra-Low Power Reflective Metasurface Amplifier Element

Polarization-Insensitive Metasurface with High-Gain Large-Angle Beam Deflection

Design of a Broadband Ka-band MMIC LNA Using Deep Negative Feedback Loop.

Metasurface: Enhancing Gain of Antenna and Energy Harvesting System Design

An Ultra-wideband Low-loss Reconfigurable Metasurface Element with 1-Bit Resolution

Design of Multi-bit Reflective Metasurface Element Based on SP4T RF Switch

Broadband Actively Amplifying Metasurface for Reconfigurable Amplitude Enhancement

Ultralow Scattering and Broadband Metasurface Using Phase Adjustable FSS Elements Embedded With Lumped Resistors

Wide-angle Low-Scattering Transmitarray Antenna Based on Transmit-Reflect Selective Metasurface

A 57-GHz CMOS Reflection Amplifier in 90-nm CMOS

Adjustable Wideband Reflective Converter Based on Cut-Wire Metasurface

Space-Energy Digital-Coding Metasurface Based on an Active Amplifier

One-bit reconfigurable reflective metasurface based on electromagnetically wideband element

Active polarization-converting metasurface with electrically controlled magnitude amplification

Broadband Mid-Infrared Antireflection Metasurfaces Based on Silicon

Achieving Directive Radiation and Broadband Microwave Absorption by an Anisotropic Metasurface

Low-Cost Air Gap Metasurface Structure for High Absorption Efficiency Energy Harvesting

Controllable Reflection-Enhancement Metasurfaces via Amplification Excitation of Transistor Circuit

Embedded circuit analysis and design method for reconfigurable metasurface element

High-performance ultra-broadband absorption–diffusion integrated metasurface

Dual-Band Nonreciprocal Transmissive Metasurface for Dynamic Manipulation of Amplitude Enhancement