Investigation on Gas-Liquid Two-Phase Frictional Pressure Drop in Pipeline Riser

Nailiang Li,Bin Chen

DOI: https://doi.org/10.1016/j.geoen.2023.212627

2024-01-01

Geoenergy Science and Engineering

Abstract:The pressure drop characteristics of gas-liquid two-phase flow in pipeline-risers are important to the design optimization of marine risers lifting oil and gas. In this study, experimental investigation on single-phase and airwater two-phase flow pressure drop characteristics in vertical and S-shaped risers have been carried out in a longdistance pipeline with the gas superficial velocities ranging from 0.03 to 6.2 m/s and the liquid superficial velocities from 0.02 to 1.3 m/s. The test loop with 50 mm i. d. Consists of a horizontal pipeline with 114 m in length, followed by a 16 m downward inclined section, and ended at a riser. The downward section is adjustable in inclination with various angle of -2 degrees, -3 degrees, -4 degrees and -5 degrees with respect to horizontal. A vertical riser and an Sshaped flexible riser were used in the experiment. The effects of flow and geometry parameters on two-phase frictional pressure drop multiplier are studied. For flow parameters, the two-phase frictional pressure drop multiplier increases with increasing the inlet gas and liquid superficial velocity. For geometric parameters, the two-phase frictional pressure drop multiplier in S-shaped riser is larger compared to that in straight vertical riser. The existing correlations reported in the literature are evaluated. A single-phase friction factor correlation and a two-phase frictional pressure drop multiplier correlation for pipeline-riser system are developed. Comparison of the predicted value and the measured results shows good agreements.